User manual DIRT DEVIL EG1200

[. . . ] Keep openings free of dust, lint, hair and anything that may reduce airflow. Keep hair, loose clothing, fingers and all parts of body away from openings and moving parts. Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. [. . . ] C) Use the low setting for short napped carpets and the high setting for plush carpets. CAUTION: Do NOT leave the EG1200 running in one spot in the upright position for any length of time. Damage to carpet may occur. Attachments Using attachments on the hose handle: Fig. D) NOTE: if the EG1200 is attached, turn the powerhead off before removing handle from wands. In some cases, the button may need to be depressed to allow the attachment to slide up higher where it can seal on the metal tube. To remove the wands from the EG1200, lock wands in straight-up position. Disconnect cord and steady the EG1200 with foot and turn wands until lock button disappears, then pull the wands out. In some cases, the button may need to be depressed to allow the attachment to slide up higher where it can seal on the metal tube. Fig. G Performance Features Edge Cleaner Active brush edge cleaners are on both sides of the EG1200. Guide either side of the EG1200 along baseboards or next to furniture to help remove dirt trapped at carpet edges. Overload Protector The EG1200 has built-in protection against motor and belt damage should the brush jam. If the brush slows down or stops, the overload protector button pops up and shuts off the EG1200. The power unit will continue to run. Suction Control The suction control allows you to change the vacuum suction for different fabric and carpet weights. Opening the control decreases suction for draperies and lightweight rugs, while closing the control increases suction for upholsteries and carpets. Maintenance and Care WARNING!!!Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. Always follow all safety precautions specified when caring for your EG1200. Changing the Light Bulb 1. Remove the light cover by pressing in and lifting both sides as shown. Close light cover until it snaps in place. Maintenance and Care Belt Changing & Brush Cleaning Disconnect hose and brush from electrical outlet. [. . . ] warrants that the EG1200 Electric Powerhead, when used for household purposes, pursuant to Seller’s instructions, will be free from defects in materials and workrkmanship for a period of one (1) year from the date of the initial consumer purchase. warrants that the EG1200 Electric Powerhead, when used in a commercial application, pursuant to Seller’s instructions, will be free from defects in materials and workmanship for a period of ninety (90) days from the date of the initial sale by H-P PRODUCTS, INC. This warranty is limited to the replacement of defective parts and any costs of shipping shall be incurred by the purchaser. [. . . ]