User manual DE DIETRICH DWSL980X

[. . . ] If the appliance has been delivered to your home in a horizontal position, stand it vertically and then wait 2 hours before plugging it in. A small amount of oil may have run into the refrigeration circuit, and you must leave it time to flow back towards the motor before connecting the appliance. Carry out an initial cleaning operation (see "Installation of your appliance" chapter) before connecting your appliance to the electrical supply. Disconnect your appliance prior to carrying out any maintenance operation. [. . . ] You can, if you wish, reverse the door opening: 1- Unscrew the upper hinge, unhinge and remove the door. 4- Screw the support to the left side of the door and replace the hinge pin. How to carry out your initial installation 5- Fit the plinth end into the space provided for the hinge bracket. 7- Reposition the door on the lower hinge pin, put the upper hinge in place and screw on. Remove the screws and block the holes with the plugs supplied with these instructions. If necessary, you can adjust the alignment of the door and the wine cellar control panel. Proceed in the following manner: 1- Open the door so that it does not impede your view. 2- Whilst holding the door, unscrew the securing screw from the upper hinge. Your appliance must be installed in compliance with the instructions given in this "Guide for Installation and Use" in order GB to keep your wine in optimum conditions and with optimal energy consumption. - The appliance should be installed in a room that is both dry and aired. - Avoid balconies, verandas, and patios: the excessive heat in summer and the cold in winter could prevent your appliance from functioning properly, or even damage it. Door lock (5) - The lock fitted to your wine cellar guarantees the protection of your wines. Putting your appliance into service - Connect to the electricity supply. - Set the thermostat knob to a medium position in the ageing zone, 11° to 14° (4) - The orange safety light (1) should be on. - the yellow light (2) may come on if the humidity rate is insufficient (see paragraph . ) - The green light(s) is/are on, or flashing, depending on the interior temperature of the wine cellar (see anomalies table). Thermost at safety indicator light (1) Your wine cellar is fitted with 2 thermostats. One is for regulation of the temperature, the other being a security in case the first one fails to work. This active security comes on as soon as electricity is supplied to the appliance (orange light on). Your wine cellar is functioning correctly when the thermostat safety light (1) is on as well as the regulating lights (3) - If however only the orange light (1) comes on, your wine cellar is opera30 The position on the left corresponds to the least cold temperature, and turning the knob to the right will select a colder temperature. The green lights (3) to the left of the knob allow you to control the temperature to which your cellar is set. 7° to 10° - Chilling for white wines 11° to 14° - Ideal temperature for ageing wine 15° to 18° - For bringing wine to room temperature - When putting your appliance into service, set the thermostat to a medium position (ageing zone) 11° to 14° - 4 hours after putting your appliance into service, or after any change in the thermostat setting, observe the temperature light (3) to make sure that your wine cellar is at the temperature you want. [. . . ] The vintages table is there purely as a guide, and only gives generalities. A wine from a 'mediocre' year can certainly prove to be excellent. If the door is left open (for more than a few minutes), a protection circuit will automatically turn the light off. Lamp operation will return to normal several minutes after the door is closed. [. . . ]