User manual DE DIETRICH DTV725X

[. . . ] 9 CLEANING AND MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 POSITION NEAR THE COUNTER TOP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 FINAL OPERATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 THESE INSTRUCTIONS ARE VALID ONLY FOR THE DESTINATION COUNTRIES WHOSE IDENTIFYING SYMBOLS ARE INCLUDED ON THE COVER OF THIS MANUAL. [. . . ] If the burners should go out accidentally, after about 20 seconds a safety device will be tripped, cutting off the gas supply, even if the gas tap is open. Turn off the control knob and wait at least 1 minute before trying to re-light the burner. 9 Instructions for the user 4. 2 Practical tips for using the burners For better burner efficiency and to minimise gas consumption, use pans with a flat, smooth base and a lid that have a suitable size for the burner, thus preventing the flames reaching the sides of the pan (see paragraph "4. 3 Pan Diameter"). Once the contents come to the boil, turn down the flame far enough to prevent the liquid from boiling over. To prevent burns or damage to the hob during cooking, all pans or griddles must be placed inside the perimeter of the hob. Take the greatest care when using fats or oils since they may catch fire if overheated. 4. 3 Pan diameters HOB BURNER Ø min. (in cm) 12 - 16 18 - 24 22 - 26 1 Auxiliary 4 Rapid 5 Ultra-rapid In this hob, the supplied reduced grill must only be used for Chinese wok pans. HOB BURNER Ø min. (in cm) 12 - 16 16 - 22 20 - 26 1 Auxiliary 2 Semi rapid 5 Ultra-rapid The following are the diameters of the pans that can be used with the raised pan stand: HOB BURNER 1 Auxiliary 2 Semi rapid 5 Ultra-rapid 10 Ø min. (in cm) 16 - 26 22 - 26 26 - 34 Instructions for the user HOB BURNER Ø min. (in cm) 12 - 20 16 - 24 20 - 26 1 Auxiliary 2 Semi rapid 5 Ultra-rapid The following are the diameters of the pans that can be used with the raised pan stand: HOB BURNER 1 Auxiliary 2 Semi rapid 5 Ultra-rapid Ø min. (in cm) 12 - 16 18 - 26 20 - 31 1 Auxiliary 3 Reduced rapid 6 Dual control HOB BURNER 1 Auxiliary 3 Reduced rapid The following are the diameters of the pans that can be used with the raised pan stand: Ø min. (in cm) 12 - 16 18 - 26 HOB BURNER 3 1 1 Auxiliary 3 Reduced rapid HOB BURNER 1 Auxiliary 3 Reduced rapid Ø min. The small brackets in figure 2 are only positioned after having mounted the hob. 2) 17 Instructions for the installer PGA64F PSFA906 PGA75F3 - PGA75FSC3 3) PGA95F3 - PGA95FSC3 4) (only "906" models) If laminated surfaces are used, it is advisable to spread a layer of anti-infiltration "primer" across the milled surface. Important: Other types of installation are possible if supervised by the manufacturer! 18 Instructions for the installer Obstructions: location of gas and electric connectors (measured in mm). PGA64F PGA75F3 - PGA75FSC3 PGA95F3 - PGA95FSC3 PSFA906 PGA32 24, 7 Precautions: the temperature of the inside surface of the hob may exceed 125°C. To avoid any hazardous situations, over-the-hob access must be restricted. Refer to the installation instructions. 31, 5 228 122 14, 2 480 19 Instructions for the installer IMPORTANT: if the appliance is mounted on a unit, make sure that a separating shelf is installed, as shown in the figure. However, if the appliance is on an oven installed under the hob, there is no need to install a separating shelf. If installed on top of an oven, the latter must be equipped with a cooling fan. 20 Instructions for the installer 6. 3 Clearances above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances ­ (Measurement A) Range hoods and exhaust fans shall be installed in accordance with the manufacturer's instructions. However, in no case shall the clearance between the highest part of the hob of the cooking appliance and a range hood be less than 600 mm or, for an overhead exhaust fan, 750 mm. Any other downward facing combustible surface less than 600 mm above the highest part of the hob shall be protected for the full width and depth of the cooking surface area in accordance with Clause 5. 12. 1. 2. However, in no case shall this clearance to any surface be less than 450 mm. 2 Side clearances ­ (Measurements B & C) Where B, measured from the periphery of the nearest burner to any vertical combustible surface, is less than 200 mm, the surface shall be protected in accordance with Clause 5. 12. 1. 2 to a height C of not less than 150 mm above the hob for the full dimension (width or depth) of the cooking surface area. Where the cooking appliance is fitted with a `splashback', protection of the rear wall is not required. [. . . ] flexible hose according to AS/NZ1869 & be at least Class "B", 10 mm diameter. The appliance must be installed with provision to allow the gas to be turned off and disconnected for servicing and removal of the appliance as required from the gas supply. Before the appliance is operated make certain all relevant parts are placed in the correct position. On completion of the installation, the installer MUST check for gas leaks and test each burner individually for the correct flame. [. . . ]