User manual DE DIETRICH DTV720X

[. . . ] 39 USING THE HOB. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 CLEANING AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 56 POSITIONING ON THE HOB TOP. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59 THESE INSTRUCTIONS ARE VALID FOR THOSE COUNTRIES IDENTIFIED BY THE SYMBOLS REPORTED ON THE COVER OF THIS MANUAL. [. . . ] To switch off a zone, reset the knob to 0. The two displays next to the cooking zones indicate the cooking power and special "Booster" and "Automatic heating" functions. 42 Instructions for the user 5. 2. 2 Booster function The induction hob has a booster function for reaching the required temperature quickly. The booster generates a temporary power output higher than the nominal power of the cooking zone itself. The booster is activated by rotating the knob clockwise to position P. The symbol on the display for the selected zone lights up to indicate that the booster function is active. The booster remains active for a maximum of 10 minutes, after which it switches itself off. The symbol will flash for 3 seconds prior to the booster function switching off. The booster function will also automatically switch off when the temperature of the hob exceeds the set point of the built-in power controller. If the knob is returned to position P while the booster function is still active, the maximum power value [9] will appear on the display. The function can also be switched off by rotating the knob anticlockwise to a lower power level. Below is a table with the minimum diameters for pans according to the cooking zone. 44 Instructions for the user COOKING ZONE OF THE HOB Ø min. (in cm) 5 4 5 Small induction zone Large induction zone 9 14 4 Pans that are larger than the cooking zones can also be used, but care must be taken that the bottom of the pan does not come into contact with other cooking zones and that it is always centred on the cooking zone perimeter. Make sure you only use containers intended for induction cooking, with a thick and completely flat bottom or, if not available, containers without a curved bottom (concave or convex). 45 Instructions for the user 5. 3. 1 Pan detection Every cooking zone has a cookware detector that only starts the cooking if there is a well positioned container with the suitable characteristics present on the hotplate. · When the resistance is raised, take care not to activate the control device. Danger of burns! 49 Instructions for the user 5. 5 Teppan yaki hob This hob enables food to be cooked or heated directly on the plate, with or without oil. This kind of cooking uses temperatures that never exceed the smoke points of the food (i. e. the temperatures at which food starts to burn) and very rapid cooking times. Saucepans or other cookware can also been used, but the time taken to reach the required temperature is naturally longer. Further information on using cookware can be found in paragraph "5. 9 Precautions when using the teppan yaki plate". The appliance has two cooking zones of equal power levels and diameters. They are positioned roughly at the front half and the rear half of the plate. Under each cooking zone there is a coil called inductor which is powered by an electronic system and which creates a variable magnetic field. When the teppan yaki plate is positioned within this magnetic field, the high frequency currents are concentrated directly onto the plate producing the heat required for heating and cooking the food. P 50° P 50° 200° 160° 100° 200° 160° 100° The symbol adjacent to the knobs indicates the cooking zone they control. Adjustment is continuous, so the appliance functions when set to the intermediate values as well. [. . . ] In order to remove the tray under the barbeque resistance: 1 Remove the rack as described. 2 Lift the resistance and block it, sliding the hold to the right (as shown in the figure). 3 Remove the basin using the two handles and clean using specific cleaning products for stainless steel and a soft sponge. * WARNING: · Before lifting the resistance up, make sure it is cool. · When the resistance is raised, take care not to activate the control device. [. . . ]