User manual DE DIETRICH DTV720J

[. . . ] This will allow you to achieve an airtight seal with the worktop. 4 tion ila nt ve Dimensions depending on your model cm spa ce Attach the clips to the hob. (Depending on the model. ) 19 9964-2701_ML. qxp 06/04/2007 16:16 Page 20 EN 1 / INSTALLING YOUR APPLIANCE Connection These hobs must be connected to the mains using a socket in compliance with publication CEI 60083 or an all-pole circuit-breaker device in compliance with the installation rules in force. When power is first supplied to your hob, or after an extended power cut, an indicator light will appear on the control panel. [. . . ] 1 -Stop table only COOKING ZONE WITH BOOST Press the touch control power on the burner. ; you will get full 2 - Keep your finger on the touch control 0 until you see displayed. . . "0". . 3 - Set the duration up to 99 minutes To stop the timer, press simultaneously the "-" + and "+" of the timer. Tip You cannot use the independent timer if the cooking zones are on. 24 9964-2701_ML. qxp 06/04/2007 16:17 Page 25 2 / USING YOUR APPLIANCE EN SETTING THE TIMERS There is a timer available for each cooking zone to set the cooking time. USING THE "CHILD SAFETY" FUNCTION This function allows you to lock your hob when it is shut off or when it is cooking. To lock: - Press on the touch control until you hear a beep and the indicator lights up. To unlock: - Press on the touch control until you hear a double beep and the indicator goes out. Note: - In locked mode, any action will produce a key symbol on the display. - If you activate the lock while cooking, the stop display will be prioritised on the lock. By pressing the button repeatedly you can highlight and select the cooking zone to which you wish to apply the timer. To use the timer: : 1 - Turn on the cooking zone 2 - set the power level. When the cooking is finished the zone swit0 ches off, the timer starts flashing "0" and a beep sounds to let you know. NOTE: - When the cooking finishes, the display shows 0 and a beep sounds about every 5 seconds for a little while. To cancel these indications, press any touch control for the cooking zone MEMO. - When using MEMO you can return at any time to normal operation (except MEMO) by pressing the touch controls "-", "+" "preselections" to change your setting, or "stop" to stop your cooking. To programme a cooking cycle: 1 - Place your cookware on the cooking zone. 3 - Press briefly the touch control MEMO 4 - Set the power level for the first cycle for the burner you have chosen, for which you want to programme a cooking cycle. Replace an existing cooking cycle program: 5 - Set the zones with extension if necessary; adding or removing extensions will not be taken into account in the other cycles. 6 - Continue cooking; each new setting will be recorded as well as the cooking time. Confirm and stop the programming by pressing the stop touch control An indicator in the timer zone shows the burner you have programmed. 3 - Press and hold the touch control MEMO Warning When using a zone with extension, you can choose the zone only when setting the first cycle. 4- Set the power level for the first cycle for the burner you have chosen, for which you want to programme a cooking cycle. [. . . ] The electrical connection of your hob is incorrect. WHAT SHOULD YOU DO? Nothing, the light disappears after 30 seconds. See the "Electrical Connection" section. On switching on YOU OBSERVE THAT: The hob does not operate and the indicator lights on the control panel do not light up. The hob does not function, the information is displayed. POSSIBLE CAUSES: The machine is not connected to the power source. [. . . ]