User manual DE DIETRICH DTV715J

[. . . ] 9 USING THE HOB. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 CLEANING AND MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 POSITIONING ON THE HOB TOP. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 THESE INSTRUCTIONS ARE VALID FOR THOSE COUNTRIES IDENTIFIED BY THE SYMBOLS REPORTED ON THE COVER OF THIS MANUAL. [. . . ] The symbol on the display for the selected zone lights up to indicate that the booster function is active. The booster remains active for a maximum of 10 minutes, after which it switches itself off. The symbol will flash for 3 seconds prior to the booster function switching off. The booster function will also automatically switch off when the temperature of the hob exceeds the set point of the built-in power controller. If the knob is returned to position P while the booster function is still active, the maximum power value [9] will appear on the display. The function can also be switched off by rotating the knob anticlockwise to a lower power level. 5. 2. 3 Automatic heating control The automatic heating control is used to provide maximum power to a cooking zone for the period of time applicable to the selected power. At the end of this time period, the automatic control will switch off and the previously selected power will appear on the display. To activate this function, rotate the knob anticlockwise to position A . After this time, the automatic heating control will switch in and the symbol will be displayed until the function switches off. When the automatic heating control switches off, the display will indicate the previously selected power value. The automatic heating control can be switched off by rotating the knob to a higher or lower power, or by activating the booster function. 13 Instructions for the user 5. 2. 4 Operating power settings Below is provided a table with the maximum power consumptions of the hotplates. Danger of burns! 19 Instructions for the user 5. 5 Teppan yaki hob This hob enables food to be cooked or heated directly on the plate, with or without oil. This kind of cooking uses temperatures that never exceed the smoke points of the food (i. e. the temperatures at which food starts to burn) and very rapid cooking times. Saucepans or other cookware can also been used, but the time taken to reach the required temperature is naturally longer. Further information on using cookware can be found in paragraph "5. 9 Precautions when using the teppan yaki plate". The appliance has two cooking zones of equal power levels and diameters. They are positioned roughly at the front half and the rear half of the plate. Under each cooking zone there is a coil called inductor which is powered by an electronic system and which creates a variable magnetic field. When the teppan yaki plate is positioned within this magnetic field, the high frequency currents are concentrated directly onto the plate producing the heat required for heating and cooking the food. P 50° P 50° 200° 160° 100° 200° 160° 100° The symbol adjacent to the knobs indicates the cooking zone they control. Adjustment is continuous, so the appliance functions when set to the intermediate values as well. To switch off a zone, reset the knob to 0. 5. 6 Display The two displays at the side of the knobs provide information on the power levels, heating and cooling of the plate, as well as the special "Booster" function. [. . . ] In order to remove the tray under the barbeque resistance: 1 Remove the rack as described. 2 Lift the resistance and block it, sliding the hold to the right (as shown in the figure). 3 Remove the basin using the two handles and clean using specific cleaning products for stainless steel and a soft sponge. * WARNING: · Before lifting the resistance up, make sure it is cool. · When the resistance is raised, take care not to activate the control device. [. . . ]