User manual DE DIETRICH DTV1103X

[. . . ] ß Immediately call your gas supplier from a neighbor's phone. ß If you cannot reach your gas supplier, call the fire department. ­ Installation and service must be performed by a qualified installer, service agency or the gas supplier. (In Massachusetts a licensed plumber/gasfitter) ­ Note to the installer: Please leave this instruction book with the consumer for the local electrical/gas inspector's use. 2 Contents IMPORTANT SAFETY INSTRUCTIONS . [. . . ] ­ Pots with a smaller diameter than the pan support and pots that do not sit securely (without wobbling) are hazardous and should not be used. Thin pan bases will conduct the heat faster but not as evenly as thick pan bases. Stir the food frequently to prevent burning. 13 Using the cooktop Safety feature This appliance is equipped with an ignition safety control. This control cuts the gas supply if the flame goes out and re-ignition is unsuccessful. ^ To re-ignite the burner, turn the control knob to "ß", then follow the procedure outlined in "Turning on and off / Regulating". This safety feature is not operated by electricity, it will be active even if the appliance is in use during a power failure. Using the cooktop during a power failure If there is an interruption to the electrical supply, the gas can be ignited using a match. ^ Press down and turn the desired control knob counter-clockwise to the largest flame symbol. ^ While holding down the knob, light the gas at the burner with a match. ^ When the flame appears, keep the control knob pressed in for about 8-10 seconds to allow for the ignition safety control to reach operating temperature. 14 Cleaning and care Grates, Control Knobs Never use scouring agents or pads, abrasive cleaning agents or strong cleaners such as oven sprays, stain or rust removers, as these could damage the surface of the appliance. The surface of the cooktop can be cleaned using a cleaner for ceramic surfaces. After cleaning, the ceramic surface must be thoroughly dried with a soft cloth to prevent a build up of limescale deposits. Do not use any sharp pointed objects which could damage the seal between the ceramic surface and the surrounding frame or between the frame and the countertop. a = minimum distance between cooktop and a tall cabinet: 6" (152 mm) Deep fat fryers must not be installed next to gas cooktops. A distance of at least 6" (152 mm) should be maintained between these two appliances. The minimum distance between two cooktops must be 4" (10 cm). recommended possible but not recommended not allowed 22 Important safety instructions for installation Cooktops should not be installed above a dishwasher, washer, dryer, freezer or refrigerator. Install the appliance so that the power cord or gas piping does not come into contact with any portion of the cooktop which may become hot during use. This equipment has not been designed for maritime use or for use in mobile installations such as aircraft or recreational vehicles. However, under certain circumstances it may be possible for an installation in these applications. Please contact the nearest Miele Dealer or the Miele Technical Service Department with specific requirements. This appliance must be installed with its own shut off valve and the included gas pressure regulator. Both the valve and the regulator must be easily accessible to the consumer to turn on or shut off the gas supply after the appliance is installed. This appliance must be disconnected from the gas supply during any pressure testing of that system performed in excess of 1 /2 psi (3. 5 kPa), or isolated at test pressures equal to or less than 1 /2 psi (3. 5 kPa). Any pipe connections must be made using a thread sealant approved for gas connections. [. . . ] Make sure that any drawers, cabinet doors, etc. , do not rub on this gas hose. 31 Gas connection Nominal Rating Table KM 391 NG / LP-Gas Auxiliary burner Max. output 41800 12. 25 15300 650 4. 48 0. 19 9500 1700 2. 78 0. 50 6000 1000 1. 76 0. 29 BTU/hr 5000 700 kW 1. 47 0. 21 32 Converting to another type of gas All cooktops come set for connection to either natural gas or LP gas. The adjustment of the included regulator corresponds with the gas type of the cooktop. If the appliance is to be connected to another type of gas than it is set for, both the regulator and burners must be converted. To convert the regulator: ^ Unscrew the hexagonal silver cap located on the top of the regulator. [. . . ]