User manual DE DIETRICH DTI1047GC

[. . . ] Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. You MUST read it carefully before installing or using the appliance. Installation q Check your dishwasher for any transport damage. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. [. . . ] Screw on the cap tightly turning it clockwise until it stops with a click. LE SA UT ZO LT SA LZ SA L SE SR14 The salt container will require topping up periodically. You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished. The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. Do not worry if water over flows from the unit when filling with salt, this is quite normal. 8 Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. q If you are using dishwasher detergent that already contains rinse aid, it is necessary to deactivate the inflow of rinse aid, in order to avoid a double dosage. Deactivation/activation of the inflow of rinse aid (The dishwasher must be switched off) Factory setting: inflow of rinse aid activated When the inflow of rinse aid has been deactivated, the rinse aid indicator light on the control panel is automatically deactivated. If a programme push button indicator light is on, this means that a washing programme has been set. The programme must be cancelled: press simultaneously the function push buttons 2 and 3 for about 2 seconds. All the indicator lights will turn off (except for the On/Off indicator light and eventually salt and rinse aid indicator lights) indicating that the setted programme has been cancelled and the machine is now in setting mode. Press simultaneously function push buttons 2 and 3, until the indicator lights of the function push buttons 1, 2 and 3 start flashing. Press the function push button 2, the indicator lights of function push buttons 1 and 3 turn off while the indicator light of the function push button 2 goes on flashing, at the same time the indicator light End of programme illuminates indicating that the inflow of rinse aid is active. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the basket is in the higher position you will not be able to use the cup rack(s). The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces. Light items (plastic bowls etc. ) must be loaded in the upper basket and arranged so they do not move. US75 RC01 After loading your machine always close the door, as an open door can be a hazard. Before closing the door, ensure that the spray arms can rotate freely. US74 11 Use of detergent Only use detergents specifically designed for use in dishwashers. Using no more then the correct amount of detergent contributes to reducing pollution. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Fill with detergent 1. The marking indicates the dosing levels: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent DE19 DE22 3. All programmes with prewash need an additional detergent dose (5/10 g) that must be placed in the prewash detergent chamber (3). Close the lid and press until it locks in place. Different kinds of detergent Detergent tablets Detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets cannot dissolve and develop their full cleaning power during short programmes. [. . . ] - 3 flashes of the indicator light "End of programme". Possible cause The water tap is blocked or furred with limescale. The filter (where present) in the threaded hose fitting at the water inlet valve is blocked. The water inlet hose has not been correctly laid or it is bent or squashed. The water drain hose has not been correctly laid or it is bent or squashed. Solutions Clean the water tap. [. . . ]