User manual DE DIETRICH DOP750W

[. . . ] Do not store items or food of interest to children in the cabinets above the appliance. Children could be seriously burned or injured if they climb on the appliance to reach these items. Do not store or use gasoline or other flammable vapors and liquids near this or any other appliance. Be certain all packing materials are removed from the unit before operating, to prevent fire or smoke damage should the packing material ignite. [. . . ] This appliance is equipped with a threeprong grounding plug for your protection against shock hazard and must be plugged directly into a properly grounded receptacle. (Model with 1½ oven cavity only) Installation Instructions for installing a 1½ cavity oven into an existing 2 cavity opening with dimensions 42 1/8" height by 22 ½" Width. The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded. preferred Method Do not, under any circumstances, cut, remove, or bypass the grounding prong. Power supply cord with 3-prong grounding plug If width opening is too wide to secure unit to cabinet with mounting screws, add filler strips. Lower trim (not shown) - overlap cabinet front (at bottom of cutout ¼" minimum. Where a standard 2-prong wall receptacle is installed, it is the personal responsibility and obligation of the consumer to have it replaced by a properly grounded 3prong wall receptacle. Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. If an external electrical source is used, the appliance, when installed, must be electrically grounded in accordance with local codes or in their absence of local codes with the National Electric Code ANSI/NFPA No. Check all code rules and regulations for connecting the wall oven to be certain the installation conforms with all local, municipal and state codes as well as local utility regulations. Failure to comply with the above could result in a serious shock hazard. To avoid pilot outage (if applicable) close all openings in the cabinet cavity that encloses this unit. All openings around gas service outlets must be closed at the time of installation. Model With 2 Oven Cavities only iMPORTANT: Refer to the serial plate for information on type of venting , if marked vented , see proper instructions. For specified models with outside venting provided (see specification sheet), use the following instructions for proper installation of outside venting. Remove knockout on the top cover of the unit and bend tab up at right angle to the cover. In order to fasten pipe to flue collar, it will be necessary to move control panel out of the way and reach in to drive screw. Model with 1 ½ oven cavity (see figure 9) Pressure Regulator Shut-Off Valve BEFORE CONNECTING THE UNIT Remove all packing material and literature from wall oven before connecting gas and electrical supply to the appliance. if applicable , remove broiler or storage drawer by pulling drawer out to stops. Leak testing of the appliance shall be conducted according to the manufacturer's instructions. 3/8" Nipple Adaptor or Union Solid Pipe Or Flex Connector Check for leaks. If a manometer is not available shut all pilots off, turn the gas supply on the unit and use a liquid leak detector at all joints and connections. [. . . ] Waist-High Broiler Spud Figure 13 Remember, the oven will be shipped from the factory set for Natural Gas, unless otherwise stated. If connecting to LP gas, be sure to follow procedure under "Conversion" to change the regulator and burner orifice to the LP setting. It should be steady with a blue cone approximately 1" and should not extend out over the edges of baffle. For LP Gas, this will most likely occur when the air adjustment shutter is completely open (see figure 15). [. . . ]