User manual DE DIETRICH DOD788B

[. . . ] The glass cover (only on some models), before lighting the over burners of the top and until their turning off, shall be in open position; it is important to avoid any contact with cookware during the cooking in order to save from a dangerous overheating. Important After the cooker use it is recommended to: 1) always check that the knobs are in the " " position. 2) close the cock of the gas cylinder (if you use liquefied gas) or the supply cock (in case of natural gas). IMPORTANT: The appliance must be installed only by qualified and competent technicians in compliance with the national provisions in force. [. . . ] - After use of the oven, be sure that all controls are in the off position. Oven light The symbols present on the oven control knob are different according to the models. The first function common to all is the oven light bulb switching on, identified by the symbol . Turnspit The turnspit, marked with the symbol is an optional available only in some models. Its symbol is next to the oven function symbols, for example when selecting the function "simple grill" the "turnspit" will automatically operate too. Cooking functions Simple grill This function operates the top central element which radiates heat directly over the foods. Double grill This function switches on both top elements to radiate heat directly over the foods it is possible to use this function turning the thermostat knob to the max temperature 200°c The oven door must be kept closed. This function operates the top and bottom elements and the foods are evenly cooked. This function is suitable for cooking most food (meat, fish, bread, pizza and so on). Fan oven This function operates the back circular element and the heat is very quickly spread in the oven by means of an electric/motor fan. The foods are rapidly and evenly cooked even if placed on more than one shelf. Timer Your range can be fitted with this accessory that you can wind by rotating the corresponding knob clockwise by one complete turn and set the pointer to the desired cooking time (expressed in minutes) by rotating the knob counterclockwise. Electric timer Your range can be fitted with this accessory acting both as a clock and as a timer as well. To set minutes rotate the small knob counter clockwise without pushing it. Timer with cooking end function Your range can be fitted with this double functional accessory: it can show the cooking time that has already passed and automatically turn off the oven. When the set time has run out, the symbol will switch off while the "AUTO" symbol flashes and the acoustic warning signal starts. Half-automatic working mode (end of cooking time) By pushing button 3 and setting the end of cooking time by means of button 5, both the "AUTO" and the symbols will lit up. When the set time has run out, the symbol will switch off while the "AUTO" symbol flashes and the acoustic warning signal starts. Automatic working mode (postponed cooking start time) First you should set your cooking time (both the "AUTO" and the symbols will lit up) and then the cooking end time, the symbol will switch off as previously stated. When cooking time has run out, the symbol will switch off while the "AUTO" symbols flashes and the acoustic warning signal starts. Manual working Manual working is possible only after having cleared the automatic program by pushing button 3. Acoustic warning signal The acoustic warning signal starts at the end of a program and lasts about two minutes. [. . . ] The manufacturer declines all responsibility for the nonobservance of the above mentioned regulations. ADAPTATION FOR DIFFERENT TYPES OF GAS To adapt the cooker for a different type of gas than that for which it was designed (see the labels on the inside of the Plate Warming Door), carry out the following operations: a) disconnect the appliance from the mains to avoid any accidental contact. b) replace the burner injectors on the hob: c) adjusting the minimum settings of the hob burners No adjustment of the burner primary air is required. Once the gas regulation is completed, replace the data plate inside the plate warming door with the correct one supplied with the injector set. [. . . ]