User manual DE DIETRICH DOD448BG1

[. . . ] The glass cover (only on some models), before lighting the over burners of the top and until their turning off, shall be in open position; it is important to avoid any contact with cookware during the cooking in order to save from a dangerous overheating. Important After the cooker use it is recommended to: 1) always check that the knobs are in the " " position. 2) close the cock of the gas cylinder (if you use liquefied gas) or the supply cock (in case of natural gas). IMPORTANT: The appliance must be installed only by qualified and competent technicians in compliance with the national provisions in force. [. . . ] To prevent the contact with the oven door, it is available an additional safety device. It is recommended to assemble this device in case of presence of young children. Ask for this device to the servicing centre with relative instructions for its assembling. The use of detergents, abrasive powders or paste, can damage the surfaces. It is recommended to clean immediately any lemon spots, vinegar and acid substances, in order to preserve the enamel brightness. The grids and burners can be taken away and easily washed in warm water and soda. While it is still warm clean with a cloth soaked with warm water and detergent, followed by a careful rinsing and drying. The bottom of the oven can be easily extracted and washed in the washbasin together with dripping-pan and gridiron shelf. iMPORTANT: Check the wear of the gas hosepipe connecting the cooker to the cylinder and replace it in case of anomalies. It is recommended to change it yearly; in any case within the date impressed on the hose. The replacement of spare parts and maintenance operations shall be carried out by qualified personnel only. Automatic working mode (postponed cooking start time) First you should set your cooking time (both the "AUTO" and the symbols will lit up) and then the cooking end time, the symbol will switch off as previously stated. When cooking time has run out, the symbol will switch off while the "AUTO" symbols flashes and the acoustic warning signal starts. Manual working Manual working is possible only after having cleared the automatic program by pushing button 3. Acoustic warning signal The acoustic warning signal starts at the end of a program and lasts about two minutes. Program start and check Program starts after about 4 seconds from the setting. it is possible to check the set program at any time by pushing the corresponding button. Correction and cancellation of program It is possible to correct the set program at any time by first pushing the relative programming button and then buttons 4 or 5. By cancelling the working time you will automatically cancel the working end time and vice versa. oven automatically switches off while the "AUTO" symbol flashes. The installation and regulations shall be carried out by qualified technicians only. After removing external packaging and inside packing of movable parts, make sure of the integrity of the appliance. [. . . ] The flexible hosepipe shall never cross from one side of the appliance to the other and be visible. In the need of a connection on the opposite side of the one provided, ask the manufacturer (see the address in the overleaf) for additional metal hosepipe D (fig. B) Screw the metal pipe to the coupling putting in the seal G and fix it on the back of the cooker Fig. C) Assemble the tubeholder on the other end of the pipe putting in the seal G. [. . . ]