User manual DE DIETRICH DKA861XA

[. . . ] correct use · This dishwasher is only intended for washing household utensils suitable for machine washing. Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. ⷠOnly use products (detergent, salt and rinse aid) suitable for dishwashers. ⷠAvoid opening the door whilst the appliance is in operation, hot steam may escape. [. . . ] Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Using no more than the correct amount of detergent contributes to reducing pollution. All programmes with prewash need an additional detergent dose (5/10 g) that must be placed in the prewash detergent chamber (2). When using detergent tablets; place the tablet in compartment (1) 2. The marking indicates the dosing levels: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent. Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals. Multitab function This appliance is equipped with the multitab function, that allows the use of the multitab combi detergent tablets. These products are detergents with a combined cleaning, rinsing and salt functions. They can also contain other different agents depending on which kind of tablets you choose ('3 in 1', '4 in 1', '5 in 1' etc. Close the door; the programme will start from the point at which it was interrupted. cancel a delay start or a washing programme in progress · Simultaneously press and hold the two function buttons B and C until all the programme lights come on. ⷠIf a new washing programme is to be selected, check that there is detergent in the detergent dispenser. end of the washing programme · The appliance will automatically stop and an audible signal informs you of the end of the washing programme. Leave the appliance door ajar for a few minutes before removing the dishes. Standby mode If you do not switch off the appliance at the end of the washing programme, the appliance automatically goes into standby mode. Three minutes after the end of the programme, all indicator lights go off and the digital display shows one horizontal bar. Electrolux 15 Press one of the buttons (not the on/off button), to go back to end-of-programme mode. The dishes should therefore be allowed to cool down before removing from the appliance. ⷠEmpty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. ⷠWater may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. [. . . ] Your local Water Authority will advise you on the average mains pressure in your area. The water inlet hose must not be kinked, crushed, or entangled when it is being connected. The appliance features inlet and drain hoses which can be turned either to the left or the right to suit the installation by means of the locknut. If the appliance is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. [. . . ]