User manual DE DIETRICH DHT1119X

[. . . ] Com Visit the De Dietrich Gallery, 6 rue de la Pépinière (Paris eighth district) Open from Tuesday to Saturday from 10 am to 7 pm Customer service department: 0892 02 88 04 As part of our commitment to constantly improving our products, we reserve the right to make changes to them based on advances to their technical, functional and/or aesthetic properties. Important: Before installing and using your appliance, please read this Installation and Usage Guide carefully, as it will allow you to quickly familiarise yourself with its operation. 26 22 EN - Instruction on mounting and use Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. [. . . ] Do not use it for commercial or industrial purposes or other purposes for which it was not created. Caution 23 Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the nonobservance of the instructions included in this manual. Installation Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. This hood is designed for fitting in a cabinet or on some other support. 5) First make sure the wall unit is suitable for the hood according to the dimensions specified in the drawings. Make the necessary holes for the insertion of the electric cable and the exhaust pipe. The lower and upper edges of the template must coincide with the lower and upper edges of the wall unit (without considering the possible door). For proper positioning screw the screws in the smallest holes of the bracket. Carry out the same operation on the left internal side of the wall unit (Bracket L). 8) In the case of wall units deeper than the hood it is possible to install a spacer. The spacer can cover depth differences not bigger than 5 cm Measure the difference between the wall unit depth and the hood depth and remove the excess by a cutter. Remove the front panel, taking away the screws that fix it to the hood. 11-15) Insert the hood into the wall unit sliding the brackets of the hood on the brackets fixed on the wall unit down to end stop. Get the electric cable through the special slots obtained on the wall unit. Block the hood fixing the brackets to each other with 2 screws (one each side). Pre-install the exhaust pipe connecting flange of suitable length and diameter for the fume exhaust to the outside (Exhaust version Fig. For proper fixing, make sure that the index printed on the flange coincides with the special guide obtained on the exhaust hole. [. . . ] € The kitchen is sufficiently ventilated to allow for fresh air intake. The hood working stopped Ensure that: • The power is not cut off. On the product, or on the documents The symbol accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. [. . . ]