User manual DE DIETRICH DHD599XE1

[. . . ] Note Prohibited Important to read and understand at all times Disconnect the plug from the outlet Ground to prevent an electric shock Do not disassemble Do not touch Power When not used for extended period of time, set your computer to DPM. The images here are for reference only, and are not applicable in all cases (or countries). Shortcut to Anti-Afterimage Instructions Do not use a damaged power cord or plug or a damaged or loose power outlet. â· Otherwise, this may result in electric shock or fire. [. . . ] OSD Display Source OSD Select whether to display a message when the Source is changed. Not Optimum Mode OSD Select whether to display a message when a non-compatible mode is selected. No Signal OSD Select whether to display a message when there is no input signal. MDC OSD Select whether to display a message when settings are changed by the MDC. Time Clock Set Change the current time on the selected display device according to the time set on a PC. If the time is not set on the display device, null values will be displayed. Timer z On Time: Set the time to power on the selected display device. Volume: Specify the volume of the display device when it is powered on by On Time. Source: Specify the input source of the display device when it is powered on by On Time. Repeat : Specify the period for which you want to repeat the selected Timer. Z z z z z Once: Activate the timer only one time. 3 If a cursor appears in the old group name, enter a new group name. schedule Management Creating Schedules Create and register a schedule on a group basis. 1 Click All Schedule List in the schedule section on the left side of the program window. 3 Click Add below the Device Group item, and select the group you want to add a schedule to. The schedule will be added and a list of schedules will appear in the set list window. Z Action: Select a function that will activate at the specified time and interval. Troubleshooting Guide Issue The display you want to control does not appear on the system information chart. Solution Check the connection of the RS232C cable (check that the cable is properly connected to appropriate serial port). Connecting displays with a duplicate ID can cause the displays not to be shown due to data collision. ) For a display that supports the ID in a range of 0 to 99, the ID should be set between 0 and 99. The display you want to control does not appear on the other Control Info Grids. [. . . ] The inverse number of the Horizontal Cycle is called Horizontal Frequency. Unit: kHz Showing the horizontal lines of the screen from the top to the bottom sequentially is called the Non-Interlace method while showing odd lines and then even lines in turn is called the Interlace method. The Non-Interlace method is used for the majority of monitors to ensure a clear image. This is a function that provides the best quality screen for the user by allowing the computer and the monitor to exchange information automatically. [. . . ]