User manual DE DIETRICH DHD1187X

[. . . ] If the appliance is ever sold or transferred to another person, ensure that the new owner receives the user guide. Please become familiar with these recommendations before installing and using your oven. This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental abilities, or persons lacking experience or awareness unless using it with the help of a person responsible for their safety, or under supervision and with prior instruction in its use. SAFETY RECOMMENDATIONS -- This oven was designed for use by private persons in their homes. [. . . ] ELECTRICAL CONNECTION During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The electrical connections are made before the appliance is installed in its housing. Ensure that: - the electrical installation has sufficient voltage, - the electrical wires are in good condition, - the diameter of the wires complies with the installation requirements. Warning This appliance is delivered with a H 05 VVF power cord that has three 0. It must be connected to the main power supply (which should be a 220-240 V single phase current) via a CEI 60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. If the power cable is damaged, call the aftersales service department in order to avoid danger. Warning If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. Warning If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. ASSEMBLING THE HOOD Warning The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. 1) on the wall that is centred over the cook top and that extends from the ceiling to the horizontal line drawn in the previous step (A). 1) on the wall, superimposing the line that represents the hood's axis over vertical line B (fig. 1) flush with the ceiling for support and position the notches over axis B. -- Using the rectangular cut-outs, attach the suction hood to the two brackets (fig. The size of these cut-outs allows you to adjust the position to the right or left. 1 H G Tip Correct the height and the levelness by moving the adjustment screws "G", then firmly press the hood by tightening the screws "H". 1), attach the metal ventilation shaft bracket against the wall, flush with the ceiling for support. This back-flow valve makes it possible to block the entry of air from the outside. [. . . ] Professional expertise for the general public Clearit offers you professional products and adapted solutions for the daily upkeep of your household and kitchen appliances. You may find them in conventional retail outlets, along with a complete line of by-products and consumables. The selected motor speed is sufficient for the quantity of smoke and vapours to be cleared. The kitchen is sufficiently ventilated to allow for fresh air intake. [. . . ]