User manual DE DIETRICH DHD1129B

[. . . ] Assembling the hood _______________________________________ 3 / USING YOUR APPLIANCE ?Control panel description ____________________________________ 4 / CARING FOR AND CLEANING YOUR APPLIANCE ?Changing a bulb ___________________________________________ 5 / TROUBLESHOOTING __________________________________________ 6 / AFTER-SALES SERVICE________________________________________ 04 05 06 07 08 09 10 13 13 13 13 14 15 3 EN 1 / USER NOTICES Important Keep this user guide with your appliance. [. . . ] The manufacturer will arrange for the appliance to be recycled properly, in accordance with European directive 2002/96/EC on Waste Electrical and Electronic Equipment. Consult your local authority or your retailer to find the drop-off points for used appliances nearest to your home. We thank you for your help in protecting the environment. Note Installation should only be undertaken by qualified fitters and technicians. Note Before using the carbon filter for the first time, remove the protective film. Note The accessible parts of this appliance can become hot when used with cooking appliances. 5 EN 1 / USER NOTICES ?DESCRIPTION OF YOUR APPLIANCE 37 0 Grid Door 24 557 600 - 90 0- Control panel 120 0 6 2 / INSTALLING YOUR APPLIANCE EN - The appliance must be unplugged during installation or when any repair or maintenance work is being carried out. - Ensure that the network voltage corresponds to the voltage noted on the identification plate located inside the hood. - If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. - This cooker hood is used in recycling mode with an activated carbon filter which traps cooking smells (section 4: changing the carbon filter). It can be used in evacuation mode with the addition of optional ducts. 7 EN 2 / INSTALLING YOUR APPLIANCE ?ELECTRICAL CONNECTION During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. Ensure that: - the electrical installation has sufficient voltage, - the electrical wires are in good condition - the diameter of the wires complies with the installation requirements. Note This appliance is delivered with a H 05 VVF power cord that has three 0. 75-mm2 conductors (neutral, phase and ground). It must be connected to the 220-240V single phase mains supply via an IEC 60083 standard socket which must remain accessible after installation or by incorporating a switch in the fixed wiring, as required by installation regulations. We cannot be held responsible for any accident resulting from an non-existent, defective or incorrect ground lead. If the power cable is damaged, call the after-sales service department in order to avoid danger. Note If the electrical installation in your residence requires any changes in order to hook up your appliance, call upon a professional electrician. Note If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. 8 2 / INSTALLING YOUR APPLIANCE EN ?ASSEMBLING THE HOOD Note The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In particular, the evacuated air should never be carried to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Disused ducts may only be used after approval from a competent specialist. The distance between the hob and the lowest part of the cooker hood must be between 50 and 65 cm (use the template supplied with your appliance). - Position the drilling template against the wall, use wall plugs and screws suitable for your type of wall. [. . . ] CLEANING THE OUTER SURFACES To clean the outside of your hood, use soapy water, rinse with fresh water then wipe with a soft cloth (do not use abrasive creams, scouring sponges or metal scouring pads). ?Contact after-sales service 13 4 EN 5 / TROUBLESHOOTING SYMPTOMS Ensure that: The hood is not working. . . The selected motor speed is sufficient for the quantity of smoke and vapours to be cleared. [. . . ]