User manual DE DIETRICH DHD1128X

[. . . ] (If they are not fastened securely enough, the TV may tilt forward after being installed. ) Do not use too much force and over tighten the screws; otherwise screw may be damaged and not tighten correctly. tidying cables (Only LA61**) 1 Use Cable Holder to neatly secure and position cables together. NOTE yy Remove the stand before installing the TV on a wall mount by performing the stand attachment in reverse. [. . . ] Do not scratch the lenses of the 3D glasses with sharp objects or clean/wipe them with chemicals. 12 INSTALLATION PROCEDURE / ASSEMBLING AND PREPARING ENGLISH ENG 1 2 3 4 NOTE yy Image shown may differ from your TV. Yy Your TV’s OSD (On Screen Display) may differ slightly from that shown in this manual. Yy The available menus and options may differ from the input source or product model that you are using. Yy The TV can be placed in standby mode in order to reduce the power consumption. And the TV should be turned off if it will not be watched for some time, as this will reduce energy consumption. Yy The energy consumed during use can be significantly reduced if the level of brightness of the picture is reduced, and this will reduce the overall running cost. INSTALLATION PROCEDURE Open the package and make sure all the accessories are included. You can use the TV network functions only when the network connection is made. (Depending on model) ASSEMBLING AND PREPARING Unpacking Check your product box for the following items. If there are any missing accessories, contact the local dealer where you purchased your product. Yy Do not apply excessive pressure to cause flexing/bending of  frame chassis as it may damage screen. Make sure not to hold the transparent part, speaker, or speaker grill area. ASSEMBLING AND PREPARING 17 Mounting on a table 1 Lift and tilt the TV into its upright position on a table. --  eave a 10 cm (minimum) space from the L wall for proper ventilation. Adjusting the angle of the TV to suit view (Only LA61**) Swivel 15 degrees to the left or right and adjust the angle of the TV to suit your view. ENGLISH ENG 15 10 cm 15 10 cm m 10 c 10 cm CAUTION 2 Connect the power cord to a wall outlet. Yy When adjusting the angle adof the product, watch out for your fingers. »» Personal injury may occur if hands or fingers are pinched. If the product is tilted too much, it may fall, causing damage or injury. CAUTION yy Do not place the TV near or on sources of heat, as this may result in fire or other damage. Using the Kensington security system (Only LN54/53**) The Kensington security system connector is located at the rear of the TV. [. . . ] Yy Optical Digital Audio Out is not available when connecting a headphone. English You may use an optional external audio system instead of the built-in speaker. Connect the external device and the TV with the optical audio cable as shown. Yy Audio with ACP (Audio Copy Protection) function may block digital audio output. [. . . ]