User manual DE DIETRICH DHD1101X

[. . . ] Com where you will find our latest innovations as well as all useful information. DE DIETRICH The new objects of value Constantly seeking to improve our products, we reserve the right to modify their technical, functional, or aesthetic characteristics as they evolve. Important: Before activating the appliance, read the installation and usage manual carefully to familiarise yourself more quickly with its operation. Com 23 CONTENTS 1/ FOR THE ATTENTION OF THE USER - Safety instructions - Mounting the hood - Description of the appliance 2 / HOOD INSTALLATION - Remote motor installation - Removal of the filter cartridge - Mounting the carbon filter - Electrical hook-up of the hood 3 / HOW THE HOOD WORKS 4 / CLEANING THE HOOD 5 / OPERATIONAL ANOMALIES 6 / AFTER SALES SERVICE EN 25 25 26 26 27 28 29 29 29 30 31 32 32 24 1/ FOR THE ATTENTION OF THE USER EN Important: keep these instructions for use with the appliance. [. . . ] The motor is delivered already attached to the equipment so as to avoid any damage during transportation. The motor must be removed from the hood before starting installation operations. 4) 5) 6) 7) Apply the glue to the lower part of the hood’s edge (Fig. The edge of the hood must be perfectly fixed to the upper surface of the kitchen furniture. Fix the hood inside the furniture utilising the two supplied brackets (fig. 8) Proceed with the assembly of the motor onto the body of the hood orientating the air outlet to the desired higher or lower position (Design 4). To install the motor in the rear part, proceed as follows: unscrew the plate situated in the rear part of the hood, screw the motor to the hood in place of the plate, correctly connect the motor cable and screw the plate back onto the front part of the hood. Connect the other end of the tube to the outside of the furniture for a filter installation or to the outside of the habitation for an extractor installation (Fig. Attention: To avoid damaging internal sliding components such as the electrical parts, do not make other holes in the product. 9) Position the metal box containing the electronic components in an easily accessible position for any eventual assistance intervention. 11) Once the installation has been completed and the hood has been connected to the electrical mains circuit, start the extraction of the carriage (refer to the chapter about how the hood functions) and remove all protective material (Fig. Version with exterior evacuation The hood is equipped with an air outlet (Refer to the image below). To convey smoke outwards (the flue pipe and fixing flange are not supplied). In filtering application that the stop valve doesn’t permit the entrance of wind and exhausted air. Filtering version In the case an exhausting hole is not possible, the hood can be used in filtering version. Filtered air will be evacuated in the kitchen trough a duct that conveys the air on a side of the cabinet (Fig. - REMOTE MOTOR INSTALLATION It is possible to install the motor in a remote position from the cooker hood, but it is necessary to order the DHK900 - 989580001 kit. 28 - REMOVAL OF THE FILTER CARTRIDGE - MOUNTING THE CARBON FILTER The cooker hood must be in the open position to install and remove its grease filters and charcoal filters. Remove the front panel by simultaneously pulling on the upper part of each side (Fig. The panel will rotate forwards to make it possible to access the grease filters (Fig. [. . . ] €¢ Check that the leads are well inserted into the nine-pole connector (too much pressure when making the connections could bend the contacts). Check that: • The motor speed selected is sufficient for the quantity of fumes steam present. €¢ The kitchen is ventilated well enough to allow for air intake. €¢ The charcoal filter has not been used (filtering mode version). [. . . ]