User manual DE DIETRICH DHB7939X

[. . . ] important precautions · This appliance was designed for use by private persons in their homes. Do not use it for commercial or industrial purposes or for any other purpose than that for which it was designed. When you receive the appliance, unpack it or have it unpacked immediately. This appliance can be used by children aged under 8 and by persons with diminished physical, sensory or mental capacities, or persons without any experience or knowledge, provided that they are properly attended to or are given the instructions on how to use the appliance in complete safety and that any potential risks are anticipated. [. . . ] It must be connected to a 220-240V single phase mains network via an IEC 60083 socket which must remain accessible after installation, in accordance with the installation rules. If the mains cable is damaged, call after-sales service and so avoid any danger. If the electrical installation in your home requires any changes in order to connect your appliance, contact a professional electrician. If the hood malfunctions in any way, unplug it or remove the fuse for the circuit concerned. Evacuation line, whatever its type, must not emerge in a loft space. Your hood may be connected to it via an evacuation duct (minimum 125mm dia. If your duct is less than 125mm in diameter, you must change to recycling mode. 2 - USE IN RECYCLING MODE You do not have a duct leading to the outside. The installation must comply with current regulations for the ventilation of rooms. In particular, air must not be evacuated into a duct used to evacuate fumes from appliances using gas or other fuels. Disused ducts may only be brought into service, if approved by a competent specialist. Energy saving advice To obtain the best performance from your appliance, limit the number of bends and length of the duct as much as possible. The minimum distance between the cooking surface and the lowest part of the hood is 65cm. If the instructions for a hob installed below the hood specify a distance greater than 65 cm, then that distance must be applied. 1 Fitting the ceiling support - Using a plumb line, identify the centre of The hob in relation to the ceiling support. - Fix the ceiling support with the 4 screws 2 Evacuation mode - If your hob is in recycling mode, fix the de- Flector to the ceiling support with the 2 screws provided (M). - Connect the duct to the deflector (recycle mode), or inside an external duct on the ceiling (evacuation mode). - Connect the duct to the deflector (recycle mode), or inside an external duct on the ceiling (evacuation mode). - Slot the end of the duct onto the engine 5 Installing / Fitting the body of the hood - Position your ducts on the product (H). - Take the hood, now fitted with the ducts - Place it under the duct support - Press the upper part (B) to insert the hood Into the duct support - The hood is held in place from the first notch(1st click). - You can now adjust the height of your ap- Pliance, by pushing it towards the ceiling (at least 65 cm above your hob). 6 Clamping the duct - At the required height, clamp the product 7 Fastening the duct - Lift up the internal duct and screw the 4 3 Installing the duct support - Once the duct support (C) has been cor- Rectly slotted in, insert the 4 screws (N) to support the hood. [. . . ] - Remove the two metal fixings (4) - Remove the carbon filters (3) - Fit new filter on to the filter cassettes. check that: · The motor speed selected is sufficient The kitchen is sufficiently ventilated to allow air to be taken in. Recycle and contribute towards protecting the environment by disposing of packaging in local waste containers designed for this purpose. This logo indicates that used appliances must not be mixed with other waste. [. . . ]