User manual DANBY DPA120BCCWDB

[. . . ] IMPORTANT - GROUNDING METHOD This product is factory equipped with a power supply cord that has a three-pronged grounded plug. It must be plugged into a mating grounding type receptacle in accordance with the National Electrical Code and applicable local codes and ordinances. If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the customer to exchange the existing receptacle in accordance with the National Electrical Code and applicable local codes and ordinances. The third ground prong should not, under any circumstances, be cut or removed. [. . . ] 0 hours will cancel the Auto-timer settings Using the Auto-on and Auto-off feature at the same time You can set the air conditioner to turn on and run for a set period of time and then turn off again by using the Auto-on and Auto-off features at the same time. Keep in mind that the hours displayed on the unit refer to the number of hours that will pass from the current time before the action is taken. For example: • First, set the Auto-off timer • Ensure the unit is turned on • Press the TIMER button and the Timer Off indicator light will illuminate • Press the UP or DOWN buttons to select the desired amount of hours before the unit turns off • Press the Timer button again within 5 seconds and the Timer On indicator light will illuminate • Press the UP and DOWN buttons to select the desired amount of hours before the unit turns back on 6 Operating Instructions REMOTE CONTROL INSTRUCTIONS • Use the remote control within a distance of 8 m (26 ft. 0V (dry batteries R03/LR03x2) -5°C to 60°C (23°F to 140°F) Signal Receiving Range 8m (26 feet) 7 Operating Instructions REPLACING THE REMOTE BATTERIES Your air conditioning unit comes with two AAA batteries. Slide the back cover from the remote downward to expose the battery compartment. Insert the batteries, ensure to match the (+) and (-) symbols on the ends of the batteries with the symbols inside the battery compartment. € The air conditioner will not respond if curtains, doors or other materials block the signal from the remote control to the unit. € If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly. € Do not leave the batteries in the remote control if it is not going to be used for more than 2 months. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. If the window opening is less than the minimum length of the window slider kit, use the single slider that has the hole in it and cut it to the correct size. Ensure that you do not cut the end of the slider that has the hole in it, this will ne necessary to attach the exhaust hose assembly. 9 Installation Instructions INSTALLATION IN A DOUBLE-HUNG SASH WINDOW 10 Installation Instructions INSTALLATION IN A SLIDING SASH WINDOW 11 Installation Instructions WATER DRAINAGE When the internal drain pan becomes full the unit will beep 8 times and the digital display will show error code P1. The air conditioning or dehumidifying action will stop but the fan may continue to operate. Replace the bottom drain plug, pressing firmly to ensure a tight fit and no leaks. The P1 error symbol will disappear and the unit will resume regular function once power is restored. If the P1 error persists when the unit has been drained of water, turn the unit off and unplug it from the power source for at least 5 minutes. If the P1 error persists after plugging the unit back in, please call Danby consumer care for further toubleshooting options. [. . . ] On the units by anyone other than an authorized service depot, or the unit is used for commercial If service is performed on the units by anyone other than an authorized service depot, or be unit is used for commercial appli cation, all application, all obligations of Danby under this warranty shall the void. Boundaries of Boundaries of in-home service If the appliance is installed in a location that is 100 kilometers (62 miles) or more from the nearest In Home Service If the appliance is installed in aunit must be delivered (62 miles)nearest authorized service center your unit service center your location that is 100 kilometers to the or more from the nearest Danby Service Depot, must be as service delivered to the nearest authorized Danby Service Depot, as service must only be performed by a technician qualified by Danby. Transporied for must only be performed by a technician qualified and certified for warranty service and certif warranty service by Danby. And from the service locationservicenot protected by this warranty and aret the responsihe tation charges to Transportation charges to and from the are location are not protected by this warranty and are responsibility the purchaser. [. . . ]