User manual CAT EYE CC-HB100 (HEART RATE MONITOR)

[. . . ] ® ® CC-HB1OO WITH HEART RATE MONITOR FUNCTION E Introduction Thank you for purchasing CATEYE CYCLOCOMPUTER Model CC-HB100. As well as cyclocomputer functions, this model has heart rate monitor functions, which enables safe and scientific training, by monitoring heart rate with a Wireless Heart Rate Sensor. Double pulse wireless heart rate transmission helps prevent interference caused by shocks and outer noises, offering the most accurate measuring. In addition to functioning as a cyclocomputer, it can be used as a heart rate monitor for other noncycling exercise programs. [. . . ] When adjusting the length, be careful that the wire will not hinder handlebar operation. · By using the rubber pad, attach the bracket close to the handlebar stem (Fig. 14). Rubber Pad Sensor Band A Parallel Fig. 7 Front Fork Fig. 8 Sensor Band B Marking Line of Sensor Fig. 9 Magnet Sensor Center of the Magnet Sensor About 2 mm Fig. 10 Fig. 11 Fig. 12 Bracket Wire Wire Securing Tape Rubber Pad Fig. 13 8 Fig. 14 Mounting Main Unit Lever Slide the main unit onto the bracket from front until it clicks into position. To remove the unit, pull it off forward while pushing down the lever (Fig. If not, adjust the relative positions of the magnet and sensor following the instructions. Auto (Automatic Start/Stop) Function This function enables the main unit to start or stop automatically without operation of the right symbol appears on the screen (Fig. · For best results, moisten the electrode areas or smear electrolytic cream (which is utilized for electrocardiograph) before wearing. · If skin irritation occurs, the Wireless Heart Rate Sensor can be worn over lightweight underwear; in this case, always moisten the electrode areas. Fig. 20 Electrode Area 3. Adjust the length of the attachment belt to your lower chest (breast) size (Fig. If attaching it on underwear, carefully moisturize electrode areas (Fig. Note: In cold or dry conditions, lightly moisturizing electrodes will correct any Fig. 21 10 Fig. 22 Transmitter measurement errors that may result. Adjust the position of the transmitter to locate it at the center of your lower chest (under your breast) (Fig. If it is still on, release it by pressing either the right or left button. Place the main unit in front of your body, and check if and if your heart rate is displayed. If it doesn't work, re-adjust the location of the wireless heart rate sensor and moisturize the electrode area. Note: When the main unit is used independent of the bicycle, or the bicycle is stopped, switch off the Auto (automatic start/stop) function. If auto function is on, average heart rate can not be displayed. E 4. Setting Upper/Lower Heart Rate Limit Fig. 23 Get M mode by pressing the left button, and press the right button to get stop state. 23), so get your desired number of the upper limit by pressing the right button to increase and the left to decrease. By pressing the Set button, this upper limit is set; and then the figure on lower display flashes. * Once the upper/lower limit is set, the alarm symbol will appear when your heart rate exceeds/drops down the limits (Fig. 24). Over Upper Limit Below Lower Limit Fig. 24 Notice - Battery Life Update: The expected battery life in the chest transmitter is approximately 2 years (average use of one hour per day). [. . . ] Insert a new lithium battery (CR2032) with the (+) pole upward as illustrated. * Make sure to press the AC button and set the necessary data again after replacing the CR2032 battery. Fig. 26 Packing ess for Heart CC -HB Rate 100 Senso r 2. Wireless Heart Rate Sensor Fig. 27 Transmitter Body 16 Battery Life: approx. 2 years (if worn for 1 hour per day) Note: The Wireless heart rate sensor is consuming the battery automatically while worn. [. . . ]