User manual CANDY PLE 64

[. . . ] (Check with the adhesive info label) ·Does the electricity supply line have an earth connection conforming with the standards in force?If there is not a proper earth connection at your home, please apply to an authorized technician to deal with this problem. [. . . ] ·The eventual replacement of the supplying cord must be carried on by the After Sales Service or by an Neutral agreed engineer, with a cord whose characteristics must be similar to the original one: Phase cable ·For the 4G hobs supplying cord type H05VV-F 2 (section 3G 0. 75mm ) Ground cable (Green-Yellow) ·For the 3G+E hobs, the rated current is 8. 6A. 2 Supplying cord type H05VV-F (section 3G 1mm ) ·For the 2G+2E hobs, the rated current is 13. 6A. Supplying cord type H05VV-F (section 3G 2 1. 5mm ) If you have changed the type of gas, it is important to verify the flame stability at the minimum regulation. "Gaing Access to the by-pass screw" To gain access to hob burner by-pass screws, remove the knobs from the control panel. Never loosen the others screws! 23 24 USE OF COOKTOP ELECTRICAL PLATES Turn the knob to the position for the required temperature of the hot plate. The indicator light of the hot plate will come on and the hot plate will start to heat. When cooking is completed, turn the knob to the " O" position. The maximum diameter of the pan base is 14 cm and the base should be flat. Leave the hot plate to heat up for 5 minutes before placing a pan on it the first time you use it. This will allow the heat resistant coating of the plate to harden due to burning. Do not remove food residues from the hot plates with a knife or any other hard, sharp object. [. . . ] Base surfaces should be completely flat and fit well on the cooking surface. ·For the best use of the electric hotplates and to minimize energy consumption, only pans with smooth flat bases should be used. [. . . ]