User manual CANDY GOC 791BT

[. . . ] Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners. Please check that the following items are delivered with the appliance: Instruction manual Guarantee card Energy label Failure to comply with the above can compromise the safety of the appliance. [. . . ] Do not install the product in a room where there is a risk of frost occurring. At temperature around freezing point the product may not be able to operate properly: there is a risk of damage if the water is allowed to freeze in the hydraulic circuit (valves, hoses, pumps). For a better product performance the ambient room temperature must be between +2°C and +35°C. To avoid having to empty the water container after each drying cycle, the water normally collected during the drying cycle can be discharged directly to a waste water drain pipe (the same drainage system as household sinks). The waste water drain pipe system should be located adjacent to the tumble dryer. Switch off and remove the tumble dryer plug from the electricity supply before carrying out any work. Remove the rear worktop trim and the worktop surface by carefully sliding it towards the rear of the machine. The waste water container is situated at the right-hand side of the machine (viewed from the rear). Attach the hose from the kit, using the connector and pipe clips supplied, to the hose removed from the bridge connection. Take off the water container cover from the rear of the machine by removing the two screws and unclipping the cover. Break off the tab on the side of the cover and replace the cover on the machine, refit the screws. You should now have revealed a hole in the back of the cabinet next to the Cover. Carefully slide the worktop back into position ensuring that the hose is not trapped and replace the worktop rear trim with the 3 screws. Make sure that the new hose does not kink when pushing the tumble dryer into position. Ensure that the guidelines, as shown, are followed when routing the new external hose. After emptying the waste water container switch the machine ON (and press the 'START' button on electronic models) to commence with the drying program. Before using the tumble dryer for the first time: Please read this instruction book thoroughly. Wipe the inside of the drum and door with a damp cloth to remove any dust which may have settled in transit. Make sure that the laundry you are going to dry is suitable for drying in a tumble dryer, as shown by the care symbols on each item. Place clothes loosely in the drum to make sure that they don't get tangled. Do not overload the drum, large items when wet can exceed the maximum admissible clothes load (for example: sleeping bags, duvets). By care symbols These can be found on the collar or inside seam: Suitable for tumble drying. [. . . ] If the door is opened during the programme to check the laundry, it is necessary to press to recommence drying after the door has been closed. When the cycle is nearing completion the machine will enter the cool down phase, the clothes will be tumbled in cool air allowing the load to cool down. This will continue until the machine is switched OFF or the door is opened. Turn the two locking levers anti-clockwise and pull out the condenser. [. . . ]