User manual CANDY GO DV 16

[. . . ] This machine should only be used for its intended purpose as described in this manual. Ensure that the instructions for installation and use are fully understood before operating the appliance. Do not lean on the door when loading the machine or use the door to lift or move the machine. [. . . ] The plug should be accessible for disconnection after the appliance has been installed. If the mains cord on this appliance is damaged, it must be replaced by a special cord which is ONLY obtainable from the GIAS spares service. The wires in the mains lead are coloured in accordance with the following codes: Blue Brown Green and Yellow NEUTRAL LIVE EARTH Do not plug the machine in and switch it on at the mains until the installation is completed. If there is any doubt about installation, call GIAS Service for advice. Once the machine is in place the feet should be adjusted to ensure that the machine is level. Adequate ventilation must be provided in the room where the tumble dryer is located to prevent gases from appliances burning other fuels, including open fires, being drawn into the room during operation of the tumble dryer. Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. Check regularly that the air flowing through the dryer is not restricted. To ensure adequate ventilation the space between the bottom of the machine and the floor must not be obstructed. There should be a gap of at least 12mm between the machine and any obstructions. Prevent items from falling or collecting behind the dryer as these may obstruct the air inlet and outlet. It is essential to use a venting hose to carry the hot moist air away from the dryer unless the dryer is situated in a open space with a good air flow around it. re-recirculation of the moist air will prevent the efficient operation of the dryer. The hose is assembled to the machine as shown The hose may be fitted through a wall or through an open door or window. The following guidelines should be followed when installing the discharge hose. Do not use two hoses joined together as the drying performance will be reduced. Avoid the hose making U shaped curves as this will restrict the flow of air and increase the chance that water will collect in the hose. Check the hose regularly to remove any build-up of fluff or water that may have collected in it. [. . . ] Clean the filter after every drying cycle to ensure maximum dryer efficiency. IMPORTANT Always switch off and remove the plug from the electricity supply before cleaning this appliance. After each period of use, wipe the inside of the drum and leave the door open for a while to allow circulation of air to dry it. [. . . ]