User manual CANDY CT-502

[. . . ] These instructions are valid only for those countries whose ID initials appear on the Illustrations for the use of the appliance are grouped together at the end of this manual. This appliance is in compliance with the following European Directives: CE Regulation n° 1935/2004: this appliance is suitable to come in contact with food products. The glass-ceramic cooktop permits rapid vertical transmission of heat from the heating element below the cooktop to the pots or pans placed on top of it. Heat does not spread horizontally, thus at a distance of just a few centimetres from the cooking zone, the glass remains relatively cool to the touch. [. . . ] After this time, all displays and LED s go off and the touch control is in The touch control can be turned on using the power supply button (key ON/OFF). The touch control is turned on exclusively by using only the power supply button alone. Pressing the power supply button at the same time as other keys has no effect and the touch control remains in standby status. The touch control can be switched off at any time using the power supply button. This is also the case if the control has been locked with the child safety feature. With the touch control on, select a cooking zone by pressing the selection key. When the respective display shows a "0", the plate is ready. if the area is hot an H will be shown on the display for the corresponding plate. By pressing the key "+" you can select a power level and the zone will start heating up. If the cooking zone is selected using the "-" key, the initial level is 9 (the highest level available). A cooking zone can be switched off in the following way: By pressing the + and the - keys of the desired cooking zone simultaneously By selecting cooking zone 0 for the desired cooking zone by pressing the - key. If you activate the on key, the touch control goes back to standby status and the timer is shut off. ), can be carried out in increments of one minute with any of the PLUS buttons from 0 to 99 and with the MINUS button from 99 to 0. Continuous activation of PLUS or MINUS provide dynamic increase of the speed of variation up to a maximum value, with no sound signals. If the PLUS (or MINUS) key is released, the speed of increase (or decrease) goes back to its original value. The timer can be set both with continuous activation of the PLUS and MINUS keys and with continuous activation in subsequent touches (with sound signal). When the time has expired, there will be a sound signal and the display will flash. The display stops flashing and goes off (after few minutes) Turn off/modify timer The timer can be modified or turned off at any time by using the PLUS and MINUS keys (with sound signal). The timer shuts off setting the time to 0 with the MINUS key or using the PLUS or MONO keys at the same time, which will set the timer directly to 0 without shutting it off. If the touch control is turned on ( using the power supply key), the autonomous timer goes off automatically. When you turn on the touch control, you can programme an independent timer for each cooking zone. By selecting the cooking zone with the zone selection key, and then setting the power level and finally by activating the timer key, you can set the countdown for cooking zone shutdown. [. . . ] The heat produced by the oven, measured on the right side of the bottom of the hob, must be lower than 60°C. Otherwise, the heat could damage the knobs or the Touch Control system. It is advisable to use an oven equipped with an internal forced cooling system. To fix the cooktop in the housing, proceed as follows: - Position the special seal supplied [C] along the outer perimeter of the worktop, so that the ends of the gasket meet exactly without overlapping. [. . . ]