User manual CANDY CST-110 EX

[. . . ] WARNING Where the hot surface symbol is located the temperature rise during operation of the tumble dryer may be in excess of 60 degrees C. Lint and fluff must not be allowed to collect on the floor around the outside of the machine. Always allow the dryer to complete the cool down period before removing the laundry. WARNING Foam rubber materials can, under certain circumstances, when heated become ignited by spontaneous combustion. [. . . ] For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. If the appliance is not running properly or breaks down, switch it off and disconnect the plug from the socket. You may be charged for a service call if a problem with your machine is caused by incorrect installation. Tumble dryers are supplied to operate at a voltage of 230V, 50 Hz single phase. The plug should be accessible for disconnection after the appliance has been installed. If the mains cord on this appliance is damaged, it must be replaced by a special cord which is ONLY obtainable from the spares service. The wires in the mains lead are coloured in accordance with the following codes: Blue Brown Green and Yellow NEUTRAL LIVE EARTH Do not plug the machine in and switch it on at the mains until the installation is completed. If there is any doubt about installation, call GIAS Service for advice. Once the machine is in place the feet should be adjusted to ensure that the machine is level. Adequate ventilation must be provided in the room where the tumble dryer is located to prevent gases from appliances burning other fuels, including open fires, being drawn into the room during operation of the tumble dryer. Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. The water removed from the laundry during the drying cycle is collected in a container at the bottom of the dryer. When the container is full the `Plein' indicator on the control panel will light, and the container MUST be emptied. However, we recommend that the container is emptied after each drying cycle. NOTE: Very little water will collect during the first few cycles of a new machine as an internal reservoir is filled first. Tilt the water container to empty the water out through the rear hole. NOTE: If you have the option of drainage near the dryer it is possible to use the discharge kit to provide a permanent drain for the water collected by the dryer. Important: Always switch off and remove the plug from the electricity supply before cleaning the condenser. Gently pull the bottom of the kickplate so that it unclips from the dryer. The top section can then be unhinged allowing the kickplate to be completely removed. Turn the two locking levers anti-clockwise and pull out the condenser. [. . . ] If the load is too large or too wet to tumble dry the dryer will automatically go into cooldown after 185 minutes. Gently close the door pushing it slowly until you hear the door 'click' shut. The light above the push button will light up when the machine is in low heat setting. To deselect this status when the drying cycle has started it is necessary to reset the machine. [. . . ]