User manual CANDY CSNL 105

[. . . ] When the appliance location is on carpet floors, attention must be paid so as to ensure that there is no obstruction to the bottom vents. And/or incorrect operation, turn the washing machine off, close the water inlet tap and do not tamper with the appliance. Contact a Candy Technical Assistance Centre for any repairs and ask for original Candy spare parts. (mains cable) be demaged, this is to be replaced by a specific cable available from the after sales service centre. [. . . ] When you are ready to unload, press the "Crease Guard" button ­ this will drain. WOLLENS ­ after the final rinse the fabrics are left in water until it is time to unload and the button indicator blinking. When you are ready to unload, press the "Crease Guard" button, this will drain and spin ready for emptying. If you do not want to spin the clothes and activate drain only: - Turn the programme selector to the "OFF" position; - Select programme drain only ; - Switch on the appliance again by pressing the "Start/Pause" button. BUTTONS INDICATOR LIGHT The indicator light around the option buttons will light when specific options are selected. The spin cycle is very important to remove as much water as possible from the laundry without damaging the fabrics. By adjusting the control, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled altogetherposition . The programme carries out with the programme selector stationary on the selected programme till cycle ends. Cotton, linen Cotton, mixed resistant Cotton, mixed Whites Whites with Prewash Fast coloureds Fast coloureds Non fast coloureds Cotton Mixed fabrics and synthetics Mixed, resistant Cotton, mixed fabrics, synthetics Synthetics (nylon, perlon), mixed cotton Non fast coloureds cold wash Fast coloureds with Prewash Fast coloureds Fast coloureds Non fast coloureds Mixed, delicate synthetics Non fast coloureds Non fast coloureds cold wash Delicates When washing heavily soiled laundry it is recommended the load is reduced to 3 kg maximum. The spin speed may also be reduced, to match any guidelines suggested on the fabric label, or for very delicate fabrics cancel the spin completely this option is available with a spin speed selector. For the various types of fabrics and various degrees of dirt the washing machine has 4 different programme bands according to: wash cycle, temperature and lenght of cycle (see table of washing cycle programmes). 1 RESISTANTS FABRICS The programmes have been designed for a maximum wash and the rinses, with spin intervals, ensure perfect rinsing. 2 MIXED AND SYNTHETIC FABRICS The main wash and the rinse gives best results thanks to the rotation rhythms of the drum and to the water levels. 3 SPECIAL DELICATE FIBRES This is a new wash cycle which alternates washing and soaking and is particularly recommended for very delicate fabrics such as Pure Machine Washable Wool. The wash cycle and rinses are carried out with high water levels to ensure best results. This programme allows a complete washing cycle for garments specified as "Hand Wash only" on the fabric care label. The programme has a temperature of 30°C and concludes with 3 rinses and a slow spin. SPECIAL "RINSE" PROGRAMME This programme carries out three rinses with a intermediate spin. The "Mix & Wash" programme has a temperature of 40°C and alternate dynamic phases (the basket that turns) to static phases (fabrics in soak in phase of rest) with a duration programme that almost reaching the 3 hours. The first washing of new coloureds fabrics must be done separately; · In every case, never mix NON-FAST COLOUREDS fabrics. 32 MINUTE RAPID PROGRAMME The 32 minute rapid programme allows a complete washing cycle to be carried out in approximately 30 minutes, with up to a maximum load of 2 kg and a temperature of 50°C. When selecting the "32 minute rapid" programme, please note that we recommend you use only 20% of the recommended quantities shown on the detergent pack. [. . . ] This does not remain incorporated in the fabric and does not alter the colour. - The presence of foam in the last rinse water which is not necessarily a sign of inadequate rinsing. - The non-ionic surface-active agents present in the composition of washing machine detersives are often difficult to remove from the washing itself and, even in small quantities, may produce visible signs of the formation of foam. 2 If your washing machine fails to function, carry out the above-mentioned checks before calling the Candy Technical Assistance Service. [. . . ]