User manual CANDY CRU164

[. . . ] This appliance is designed for domestic use only, specifically for the storage of edible foodstuffs only. During the normal operation, the condenser and compressor located at the rear of the appliance can reach higher temperatures; ensure that installation is carried out according to the instructions in this booklet. Insufficient ventilation will impair operation and damage the appliance. [. . . ] Maximum performance and safety are guaranteed by maintaining the correct indoor temperature for the class of unit concerned, as specified on the rating plate. Climate classification SN N ST T Ambient temperature 10~32 16~32 16~38 16~43 Appliances must not be exposed to rain. Sufficient air must be allowed to circulate in the lower rear section of appliances, as poor air circulation can affect performance. Built-in appliances should be positioned away from heat sources such as heaters and direct sunlight. Electrical connection Before connecting the appliance to the power supply, ensure that the voltage and frequency as indicated on the data plate correspond to those of the electrical mains. A deviation of ­6V to +6V is admissible with respect to the rated voltage. For operation with other voltage supplies, a right autotransformer is required. Always connect the appliance to an useful earthing system For the above, if the main supply is not earthed, connect the appliance to a separate earthing system. Consult a specialized technician to carry out the latter in compliance with current standards. The manufacturer declines all responsibility for failure to observe the above accident prevention standards. 4 Cleaning the interior prior to use Prior to use, clean all internal parts with warm water and neutral detergent to remove the "new" odor and dry thoroughly. Never use abrasive detergents and/or powders that can damage the appliance. Installation instructions: Before installing, carefully read the instruction in order to avoid a certain number of problems. Fig 2 -Dimensions of mounting slot Fig 3 -Height regulation Fig 4 -Installation of the appliance under the worktop Fig 5 -Fastening the appliance under the worktop Fig 6 -Door exchange Fig 7, Fig 8 ­Mounting the kitchen cabinet door 5 6 7 6 8 7 8 9 View of the appliance Freezer Chamber IceTray Rack Cover Upper rack on the door Temperature Regulator Shelf Lower rack on the door Crisper Drawer Cover Crisper Drawer How to remove the shelf from the appliance The shelf may be placed randomly upon any of the guide slots inside the appliance. In case you want to adjust the shelves or remove the shelves from the appliance. 1Lift the shelf by hand and pull it towards you until it reaches the crack in the guide slot. 2Lift the shelf up and pull it out inclined between the door and appliance. Reinsertion is carried out in the opposite procedure. 10 Changing over the freezer compartment door Open the freezer compartment door a little way Using a small screwdriver, press the spring in the opening of the lower door bearing slightly upwards and take the door bearing out complete with the door. [. . . ] Appliances with compartments that have no symbol are unsuitable for freezing fresh foods and for storing frozen food. IMPORTANT If the food stored in the freezer compartment is unintentionally defrosted, e. g. due to a power failure, it should be consumed within a short interval even if not completely thawed. Brief interruptions (up to 6-8 hours) do not affect frozen food. Defrosting the appliance The rear wall of the fridge covers with frost when the compressor is running, and defrosts when the compressor is off. [. . . ]