User manual CANDY CE 61 X

[. . . ] The symbol on the product or on the accompanying paperwork indicates that the appliance should not be treated as domestic waste, but should be delivered to a suitable electric and electronic appliance recycling collection point. For more information on the treatment, re-use and recycling of this product, please contact your local authority, domestic waste collection service or the shop where the appliance was purchased. [. . . ] Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. Warning: if the bulbs are not working, ensure that they are screwed in fully. Installation Prior to proceeding with the assembly operations (according to the model that you have purchased), to facilitate handling of the device, remove the grille as indicated in figure 6. Fitting the front panel To make fixing the front panel in place easier, the cooker hood flap may be removed in the following manner: 1 ­ Pull the flap out until it reaches its opening limit (fig. 5C), replace everything by performing the above instructions in reverse. 4 ­ When replacing the grille, be sure to insert the buffer S into the casing, as demonstrated in figure 5D. 2) - Make 4 holes in the wall cabinet respecting the measurements indicated in figures 2 A-2 C. - Position the hood underneath the wall cabinet and fix it into place using 4 screws (supplied) suitable for the type of cabinet. - Hang the hood on the wall, using the 2 holes H, align it in a horizontal position and fix it definitively to the wall using the two safety holes I (Fig. For the various installations use screws and screw anchors suited to the type of wall (e. If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. The hood is already prepared for the version with which it was ordered. [. . . ] The illumination installation is designed for use during cooking and not for prolonged general illumination of the environment. Replacing the acrylic or metal panels To replace the acrylic or metal panels, first remove grille D by pressing the two side buttons B, as shown in fig. [. . . ]