User manual CANDY CD 834

[. . . ] Please read this booklet carefully as it provides important information regarding the safe installation, use, and maintenance of the machine, together with some useful advice on how to achieve the best results from your dishwasher. For future reference please keep this instruction booklet in a safe place. CUSTOMER SERVICE AND GUARANTEE Your new appliance is fully guaranteed by the manufacturer for 12 months against electrical/mechanical breakdown excluding: A. Any faults which occur due to bad installation or misuse of the machine. Any faults which occur due to repair of, or interference with, the machine by any person not authorised by the manufacturer to carry out service. [. . . ] If the machine comes open while it is working, an electrical safety device automatically switches everything off. IMPORTANT For the machine to work properly, the door should not be opened while it is in operation. 8 Closing the door Place the baskets in the machine. Make sure that both the spray arms are free to rotate and are not obstructed by cutlery, crockery or pans. Close the door, pressing on it to make sure it is firmly shut. 0 1 *2 3 4 FREE N. 1 N. 2 N. 3 N. 4 9 Loading the salt On the bottom of the machine there is a container for the salt for regenerating the softener. It is important to use only a salt that is specifically designed for dishwasher. Other types of salt contain small quantities of insoluble particles which over a long period of time may affect and deteriorate the softener performance. To add salt, unscrew the cap of the container on the bottom and then refill the container. During this operation a little water will overflow; but keep adding salt until the container is full. When the container is full, clean the thread of salt residue and retighten the tap. After loading the salt, it is recommended running a complete washing cycle, or COLD RINSE programme. The salt dispenser has a capacity of between 1. 5 and 1. 8 kg and, for efficient use of the appliance, it should be refilled from time to time according to the regulation of the water softener unit. We advise using 20:30 g of detergent in the wash section of detergent compartment (B). Since not all detergents are the same the instructions on the boxes of detergent can vary. We should just like to remind users that too little detergent does not clean the dishes properly whilst too much detergent will not produce better results and is also a waste. Filling the rinse aid container The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. The rinse aid container can be found to the left of the detergent container (fig. To open the lid, push the reference mark and, in the same time, pull the tab of opening. It is always advisable to use rinse aid that is specifically designed for dishwasher. Check the rinse aid level through the indicator eye (C) which is located on the dispenser. C IMPORTANT Do not use an excessive amount of detergent and help limit damage to the environment at the same time. FULL EMPTY dark light CAUTION!IMPORTANT NOTE ON THE USE OF COMBINED DETERGENTS Regulating the rinse aid from 1 to 6 The regulator (D) is placed under the lid and can be turned using a coin. The limestone content of the water considerably affects the formation of limescale and the drying performance. It is therefore important to regulate the quantity of rinse aid to achieve good washing results. If, after the wash, streaks occur on the dishes, decrease the amount by one position. If whitish spots occur, increase the amount by one position. 17 A If you are planning to use combined detergents i. e. [. . . ] A new wash setting can now be made. Setting of new programme Whenever you want to set a new programme, you MUST turn the programme selector to "RESET" position and wait for the "WASHING" indicator light to go off. IMPORTANT This dishwasher is equipped with an anti-overflow safety device which will automatically empty any excess water should a problem occur. Setting a programme Troubleshooting While you are setting a programme, the indicator light "WASHING" will start flashing very quickly if the electronics detect some incorrect programming function. In this case, turn the programme selector to the "RESET" position and the indicator light "WASHING" will then go off. If the malfunction continues, contact the After Sales Service Centre. WARNING!Before to set any programme, the programme selector must be in the "RESET" position and the indicator light "WASHING" must be out. [. . . ]