User manual CANDY C 634 XT

[. . . ] Electric Connection The appliance has been manufactured as a class II, therefore no earth cable is necessary. The connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral If not provided, connect a plug for the electrical load indicated on the description label. Where a plug is provided, the cooker hood must be installed in order that the plug is easily accessible. [. . . ] The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the cooker hood must be at least 65 cm. If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. - When installing this product we recommend you seek the help of another individual. Make 4, Ø8 holes in the ceiling and drive in 3 screws without completely tightening them. Pay attention not to insert the screw into the hole marked with an X on the hole template (the screws and expansion plugs must be suitable for the type of wall). 5) and insert the 3 slots onto the 3 screws that are not completely tightened. If the filters do not have any text on them, or if metal filters or aluminium panel filters are used, they should be washed every 2 months in order to prevent the risk of fire. To wash the filters, proceed as follows: - Remove the filter from the grille and wash it using a solution of water and neutral liquid detergent, leaving the dirt to soften. If the filters are made using aluminium, or if an aluminium panel is used, after a few washes the colour may change. If the replacement and washing instructions are not followed, the anti-grease filters may present a fire hazard. The active carbon filters are used to purify the air which is released back into the room. The filters are not washable or re-usable and must be replaced at least once every four months. The active carbon filter saturation level depends on the frequency with which the appliance is used, the type of cooking performed and the regularity with which the anti-grease filters are cleaned. Remove build-up from the fan and other surfaces of the cooker hood regularly using a cloth moistened with denatured alcohol or non-abrasive neutr al liquid detergent. The light on the cooker hood is designed for use during cooking and not for general room illumination. [. . . ] To replace the halogen lamps B, from the inside of the cooker hood press downwards with two fingers as shown in Fig. 14) LUMINOUS the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III F = AUTOMATIC STOP TIMER - 15 minutes (*) · If your appliance does not have the INTENSIVE speed function, press key E for two seconds and it will be activated for 10 minutes after which it will return to the previously set speed. By pressing key F for two seconds (with the hood We also recommend that the appliance is left running for 15 minutes after the food is cooked, in order to thoroughly eliminate all contaminated air. [. . . ]