User manual CANDY ALISE 18 WD

[. . . ] Please read this booklet carefully as it provides important guide lines for safe installation, use and maintenance and some useful advise for best results when using your washing machine. When contacting Candy or a Customer Services Centre always refer to the Model, No. On delivery, check that the following are included with the machine: Check that the machine has not incurred damage during transport. The appliance is supplied with a guarantee certificate which allows free use of the Technical Assistance Service. [. . . ] WOLLENS ­ after the final rinse the fabrics are left in water until it is time to unload and the button indicator blinking. When you are ready to unload, press the "Crease Guard" button, this will drain and spin ready for emptying. If you do not want to spin the clothes and activate drain only: - Turn the programme selector to the "OFF" position; - Select programme drain only ; - Switch on the appliance again by pressing the "Start/Pause" button. EN START DELAY BUTTON Appliance start time can be set with this button, delaying the star by 3, 6 or 9 hours. Proceed as follow to set a delayed start: Select a programme ("STOP" indicator light blinks) Press Start Delay button (each time the button is pressed the start will be delayed by 3, 6 or 9 hours respectively and the corresponding light will blink). Press START to commence the Start Delay operation (the indicator light associated with the selected Start Delay time stops blinking and remains ON). To cancel the Start Delay function : press the Start Delay button until the indicator lights will be off (The STOP light blinks) and the programme can be started manually using the START button or switch off the appliance by turning the programme selector to off position. EN SPIN SPEED BUTTON The spin cycle is very important to remove as much water as possible from the laundry without damaging the fabrics. By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. To reactivate the spin cycle is enough to press the button until you reach the spin speed you would like to set. For not damage the fabrics, it is not possible to increase the speed over that automatically suitable during the selection of the program. The wash cycle and rinses are carried out with high water levels to ensure best results. This programme allows a complete washing cycle for garments specified as "Hand Wash only" on the fabric care label. The programme has a temperature of 30°C and concludes with 3 rinses and a slow spin. SPECIAL "COTTON RINSES" PROGRAMME This programme carries out three rinses with a intermediate spin (which can be reduced or excluded by using the correct button). SPECIAL "MIXED RINSES" PROGRAMME This programme carries out three rinses with a intermediate spin (which can be reduced or excluded by using the correct button). SPECIAL "FAST SPIN" PROGRAMME Programme "FAST SPIN" carries out a maximum spin (which can be reduced by using the correct button). The "Mix & Wash" programme has a temperature of 40°C and alternate dynamic phases (the basket that turns) to static phases (fabrics in soak in phase of rest) with a duration programme that almost reaching the 3 hours. The first washing of new coloureds fabrics must be done separately; · In every case, never mix NON-FAST COLOUREDS fabrics. 32 MINUTE RAPID PROGRAMME The 32 minute rapid programme allows a complete washing cycle to be carried out in approximately 30 minutes, with up to a maximum load of 2 kg and a temperature of 50°C. When selecting the "32 minute rapid" programme, please note that we recommend you use only 20% of the recommended quantities shown on the detergent pack. When the START button is pressed the machine sets the working sequence in motion. [. . . ] Switch off the machine by turning the programme selector on the "OFF" position. Very dirty cotton) and without pressing Start button, prepare wash as described: Cotton), programme the drying as follows: If you would like your fabrics cupboard dry, press the "drying programme selection" button until the indicator lights up. EN If you would like your fabrics iron dry, press the "drying programme selection" button, until the indicator lights up. If you wish to select a timed drying cycle, press the "drying programme selection" until the "Timed" indicator lights up. [. . . ]