User manual BRAUN SI6225

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BRAUN SI6225. We hope that this BRAUN SI6225 user guide will be useful to you.


BRAUN SI6225 : Download the complete user guide (421 Ko)

You may also download the following manuals related to this product:

   BRAUN SI6225 annexe 1 (421 ko)
   BRAUN SI6225 annexe 1 (421 ko)
   BRAUN SI6225 annexe 1 (421 ko)
   BRAUN SI6225 annexe 2 (298 ko)

Manual abstract: user guide BRAUN SI6225

Detailed instructions for use are in the User's Guide.

[. . . ] Do not leave the iron unattended while plugged in or on an ironing board. Use caution when you turn a steam iron upside down, as there may be hot water in the reservoir. To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. Care should be taken to arrange the cord so that it cannot be pulled or tripped over. [. . . ] 6)­7) Holding the iron over a sink, press the steam button (3) so it is in the upright position, carefully pull it up, turn it and let it rest in that position. Caution: When the steam button (3) is pulled up, hot water and steam will be released from the soleplate. 8) Turn the steam button (3) back into place by pushing it down until it clicks into place. 11)­13) When the pilot light (7) goes off, press the power shot button (5) 4 times to rinse the iron. Disconnect the iron and wait for the soleplate to cool off, then clean it as described above in section E. 1 Steam on/off For steam ironing, the temperature selector (6) must be set within the red range. With the steam button (3) in the upright position, turn the steam regulator (3a) to adjust the steam quantity. Pre-Conditioning Steam (available on models SI 6285 and SI 6245) Steam comes out of the channels on the upper part of the soleplate around the front of the iron. This preconditions the fabric by «pre-steaming», thus making ironing easier. 2 Power shot Prior to use, press the power shot button (5) 3 to 4 times to activate it. However, the temperature selector (6) must be set in the range between «· The power shot function can also be used in the vertical position for steaming hanging garments or curtains. 4 Dry ironing Turn the steam mode off by pressing the steam button (3) down so that it catches in the lowered position. The «auto-off» pilot light (7) will flash when the automatic shut-off is activated. This happens when the iron has rested: ­ horizontally on the soleplate for about 25 seconds or ­ vertically on the heel rest (8) for about 12. 5 minutes or ­ when the iron has been lying on its side for about 25 seconds. When the «auto-off» pilot light (7) stops flashing the electrical power is on again. Problem Remedy Water drops Turn the steam coming out of regulator (3a) counterthe steam vents clockwise to reduce the steam or press the steam button (3) down to turn the steam off. Less steam develops or no steam at all Calcium particles coming through the steam vents Subject to change without notice. Should your Braun product require service, please call 1-800-BRAUN 11 (800-272-8611) to be referred to the authorized Braun Service Center closest to you. Take the product in to the authorized Braun Service Center of your choice or, B. Ship the product to the authorized Braun Service Center of your choice. Include a copy of your proof of purchase to verify warranty coverage, if applicable. [. . . ] It can therefore be used to iron delicate and dark fabrics without having to use a cloth between the iron and the garment. Before ironing with the Textile Protector Before using the Textile Protector for the first time, be certain to iron for approximately two minutes without it. To attach the Textile Protector, lay it flat on the ironing board, position the tip of the iron into the Textile Protector tip, pull back the plastic release, place the iron into the Textile Protector, and click it into place by letting go of the plastic release. After attaching the Textile Protector, wait approximately 1 1/2 minutes before you start ironing. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BRAUN SI6225




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BRAUN SI6225 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.