User manual BRAUN MR570 PATISSERIE

[. . . ] Before operating the food preparation attachment (15), make sure that the lid interlock (17c) is properly clicked in and that the pusher (16) is in place. Do not insert other tools than the pusher (16) into the filling tube during processing. The lid (17) can be cleaned under running water, but do not immerse it in water, nor clean it in a dishwasher. Repairs or the replacement of the mains cord must only be done by authorised service personnel. [. . . ] Start with a medium speed setting «7» and while beating, increase the speed to setting «15». €“ kneading dough (based on 250 g flour maximum) – slicing and shredding (see picture section %) Chopping (see picture section $) The blade (20) is perfectly suited for chopping meat, cheese, onions, herbs, garlic, carrots, walnuts, hazelnuts, almonds etc. Do not chop extremely hard food, such as nutmeg, coffee beans and grains. Before chopping … • pre-cut meat, cheese, onions, garlic, carrots, chilies, • remove stalks from herbs, un-shell nuts, • remove bones, tendons and gristle from meat. Place the blade on the centre pin of the bowl (18) and give it a turn to lock into place. C) Attach the lid (17) onto the bowl with the interlock (17c) positioned next to the bowl handle. To lock the lid, turn it clockwise so that the interlock engages with a «click» above the handle. E) To operate, press switch (3) or (4) on the motor part and take hold of the bowl with your other hand. G) Pressing the lid interlock (17c), turn the lid (17) counter-clockwise to unlatch it and lift it up. H) Carefully take out the blade by turning and pulling it, before removing the processed food. Mixing light dough Using the blade (20), you may also mix light dough like a pancake batter or a cake mixture based on up to 250 g fl our. For a pancake batter, for instance, first pour liquids into the bowl, then add flour and finally eggs. Kneading dough (Picture section $ a–i also applies for the use of the kneading tool. ) The kneading tool (21) is ideally suited for kneading different dough types like yeast dough or pastry (based on 250 g flour). €¢ Place the kneading tool into the food processor bowl (18). €¢ First fill the flour into the food processor bowl, then add the other ingredients except liquids. €¢ Then add liquids through the filling tube while the motor is running. €¢ After 1-minute kneading time, please allow the motor part to cool down for 10 minutes. First fill the flour into the food processor bowl, C How to operate your chopper attachment The chopper (10) is perfectly suited for chopping meat, cheese, onions, herbs, garlic, chillies (with water) carrots, walnuts, hazelnuts, almonds, prunes etc. Do not chop extremely hard food, such as ice cubes, nutmeg, coffee beans or grains. €¢ pre-cut meat, cheese, onions, garlic, carrots, chillies, • remove stalks from herbs, un-shell nuts, • remove bones, tendons and gristle from meat. For best results, please refer to the speed settings recommended in the processing table. [. . . ] This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre (address information available online at www. For UK only: This guarantee in no way affects your rights under statutory law. [. . . ]