User manual BRAUN CRUZER6

[. . . ] € Using the special cord set (8), connect the shaver to an electrical outlet with the motor switched off. € When charging for the first time or when the shaver is not used for a few months, leave the shaver to charge continuously for 4 hours. € Once the shaver is completely charged, discharge the shaver through normal use. € A full charge provides up to 45 minutes of cordless shaving time depending on your beard growth. [. . . ] However, do not clean the shaver Foil & Cutter cassette with a brush as this may damage it (picture). Keeping your shaver in top shape Replacement light for shaving parts / Reset To maintain 100% shaving performance, replace the shaver Foil & Cutter cassette (1), when the replacement light for shaving parts (6) comes on (after about 18 months) or when worn. Foil & Cutter cassette: 32S/32B The replacement light will remind you during the next 7 shaves to replace the Foil & Cutter cassette. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (3) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every six months approximately. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection sites provided in your country. Guarantee We grant a 2 year guarantee on the product commencing on the date of purchase. Within the guarantee period we will eliminate any defects in the appliance resulting from faults in materials or workmanship, free of charge either by repairing or replacing the complete appliance at our discretion. This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre (address information available online at www. For UK only: This guarantee in no way affects your rights under statutory law. For Australia & New Zealand only: Warranty In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably 13 cruZer6_clean_S6-68. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits given by this warranty are in addition to other rights and remedies of the consumer law. Com Our Warranty This appliance is also covered by a 24 Month Replacement Warranty commencing on the date of purchase (Our Warranty). Our Warranty applies in all States and Territories of Australia and in New Zealand and is in addition to any mandatory statutory obligations imposed on Procter & Gamble Australia Pty. Our Warranty does not purport to exclude, restrict or modify any such mandatory statutory obligations. [. . . ] Local Service Agents may change from time to time – in that event please contact the Consumer Service free call number below for updated local service agent details. Barbering Tryk på tænd/sluk-knappen (4) for at tænde for barbermaskinen (billedet). Hold din barbermaskine i topform Udskiftningslys for barberdele / Nulstil For at opnå optimal barbering bør kassetten med skæreblade og lamelknive (1) udskiftes, når udskiftningslyset for barberdele (6) lyser (efter ca. Inden for garantiperioden vil Braun for egen regning afhjælpe fabrikations- og materialefejl efter vort skøn gennem reparation eller ombytning af apparatet. [. . . ]