User manual BRAUN COOLTEC

[. . . ] To disconnect turn all controls to «off», then remove plug from outlet. When plugging to an electrical outlet outside the USA, use a plug adapter to match the outlet’s pin configuration. The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat above 100 °C (212 °F) or incinerate. [. . . ] €¢ In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. €¢ Do not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or lacquered surfaces. 13 14 15 16a 16b 17 18 Station power socket Lift button for cartridge exchange Station-to-shaver contacts Level indicator Status light Start button Cleaning cartridge Installing the Clean&Charge station (see fig. E) • Remove the protection foil from the Clean&Charge station display. €¢ Press the lift button (14) at the rear side of the Clean&Charge station to lift up the housing. €¢ Hold the cleaning cartridge (18) down on a flat, stable surface (e. €¢ Slide the cartridge from the rear side into the base of the station until it snaps into place. €¢ Slowly close the housing by pushing it down until it locks. €¢ Using the special cord set (10), connect the station power socket (13) to an electrical outlet. Charging the shaver in the Clean&Charge station Insert the shaver head down into the Clean&Charge station. Important: The shaver needs to be dry and free from any foam or soap residue!The contacts (7) on the back of the shaver need to align with the contacts (15) in the Clean&Charge station. Cleaning the shaver in the Clean&Charge Station When the cleaning indicator lights up in the shaver display, insert the shaver into the Clean&Charge station, upside down and with the front showing. Start automatic cleaning Start the cleaning process by pressing the start button (17). If the status light (16b) does not shine (Clean&Charge station switches to stand-by after about 10 minutes), press the start button twice. €¢ Switch the shaver on and rinse the shaver head under hot running water. €¢ Next, switch off the shaver, remove the Foil & Cutter cassette and let it dry. €¢ If you regularly clean the shaver under water, then once a week apply a drop of light machine oil on top of the Foil & Cutter cassette. Alternatively, you may clean the shaver using a brush: • Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat surface. Clean&Charge station (models CT6cc/CT5cc/CT4cc/CT3cc/CT2cc) The Clean&Charge station has been developed for cleaning, charging, lubricating, disinfecting and storing your Braun shaver. [. . . ] This warranty does not cover foil and cutter cassette or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. 12 13:18 FOR CANADA ONLY 2 year limited warranty (foil and cutter block excluded) In the event a Braun Shaver fails to function within 2 years from date of purchase, because of defects in material or workmanship, and the consumer returns the unit to an authorized service center, Braun Canada, will, at its option, either repair or replace the unit without additional charge to the consumer. [. . . ]