User manual BRAUN 3CC-4 HUGO BOSS

[. . . ] Description 1 2 3 4 5 6 7 8 9 10 11 12 Foil & Cutter cassette Long hair trimmer Precision setting switch (390cc/370cc only) On/off switch Charging lights (green) Low-charge light (red) Cleaning light (yellow) Replacement light for shaving parts Shaver power socket Special cord set Travel pouch (390cc/370cc only) Foil protection cap (350cc only) Charging Recommended ambient temperature for charging is 5 °C to 35 °C. The battery may not charge properly or at all under extreme low or high temperatures. recommended ambient temperature for shaving is 15 °C to 35 °C. Do not expose the appliance to temperatures higher than 50 °C for extended periods of time. [. . . ] Automatic cleaning Once the shaver is put into the Clean&Renew, it is cleaned automatically (see «Clean&Renew (C)»). 13 13:59 Manual cleaning is recommended only when the Clean&Renew is not available, e. Rinsing the shaver head under running water after each shave is an easy and fast way to keep it clean: • Switch the shaver on (cordless) and rinse the shaver head under hot running water. € Next, switch off the shaver, remove the Foil & Cutter cassette (1) and let it dry. € If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer (2) and Foil & Cutter cassette (1). Alternatively, you may clean the shaver using a brush: • Switch off the shaver. Remove the Foil & Cutter cassette and tap it out on a flat surface. However, do not clean the Foil & Cutter cassette with a brush as this may damage it. Replacement light for shaving parts/Reset To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when the replacement light for shaving parts (8) comes on (after about 18 months) or when worn. The replacement light will remind you during the next 7 shaves to replace the foil and cutter cassette. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection sites provided in your country. 13 13:59 Clean&Renew (C) Braun Clean&Renew has been developed for cleaning, charging and storing your shaver. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfils the lubrication needs of the shaver. Description 1 2 3 4 5 Start/release button Contact bow Lift button for cartridge exchange Level indicator Cleaning cartridge Installing the cartridge • Press the lift button (3) to open the housing. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. Operating your Clean&Renew • Connect your Clean&Renew with the cord set to the mains electricity supply. [. . . ] This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. 13 13:59 This guarantee does not cover: damage due to improper use, normal wear and tear (e. Shaver Foil & Cutter cassette) as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. [. . . ]