User manual BRAUN 350CC-4

[. . . ] 11 14:28 • A full charge provides up to 45 minutes of cordless shaving time depending on your beard growth. With normal use the shaver will be charged automatically after every cleaning in the Clean&Renew (see «C Clean&Renew»). € Maximum battery capacity will only be reached after several charging/ discharging cycles. € 5-minute quick charge (with the special cord set (10)) is sufficient for a shave. [. . . ] After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection sites provided in your country. C Clean&Renew Braun Clean&Renew has been developed for cleaning, charging and storing your shaver. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfils the lubrication needs of the shaver. Important • Only use the power supply cord set supplied with the shaver. € In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. € Do not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or lacquered surfaces. Description 1 2 3 4 5 Start/release button Contact bow Lift button for cartridge exchange Level indicator Cleaning cartridge Before using Clean&Renew Installing the cartridge • Press the lift button (3) to open the housing. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. Operating your Clean&Renew • Connect your Clean&Renew with the cord set to the mains electricity supply. After each shave, switch the shaver off and put it into the Clean&Renew, upside down and with the front showing. The yellow light on the shaver will flash during the complete process (approx. € Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use. If interruption is needed nonetheless, press the start/release button (1). 11 14:28 • When cleaning is finished, the yellow light will go off. € A cleaning cartridge should be sufficient for about 30 cleaning cycles. [. . . ] For any appliance replaced under this warranty, Our Warranty ends on the expiry of the warranty period that applied to the original appliance. This appliance is not intended for use by young children or infirm persons without supervision. 11 14:28 Norsk Våre produkter er utviklet for å oppfylle de høyeste standardene for kvalitet, funksjonalitet og design. Beskrivelse 1 2 3 4 5 6 7 8 9 10 11 Kassett med skjæreblad og lamellkniv Langhårtrimmer Bryter for presisjonsinnstilling (« ») (kun 390cc/370cc) På/av-bryter Ladelys (grønne) Varsellys for lavt batterinivå (rød) Rengjøringslys (gult) Indikatorlys for bytte av skjæredeler Barbermaskinens strømtilkobling Spesialledning Etui Oppladning Den beste omgivelsestemperaturen for oppladning er mellom 15 °C og 35 °C. [. . . ]