User manual BRANDT AD658XC1

[. . . ] Make sure that children do not touch and that they do not treat it as a toy. € When you receive the appliance, unpack or have it unpacked immediately. Make note of any concerns or reservations on the delivery slip and make sure to keep a copy of this form. Do not use it for commercial or industrial purposes or for any other purpose than that for which it was designed. [. . . ] It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. warning Installation should only be performed by installers and qualified technicians. Warning Remove the protective film from the cartridge filter before use. Qxp 19/01/2006 11:15 Page 55 2 / INSTALLING YOUR APPLIANCE EN - The appliance must be unplugged during installation or when any repairs or maintenance work is being performed. - Ensure that the network voltage corresponds to the voltage noted on the identification plate located inside the hood. - If the electrical installation at your residence requires any changes in order to hook up your Appliance, call upon a professional electrician. - If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas exhaust duct (boiler, chimney, etc. - Under no circumstances should the exhaust duct empty into the attic. - Install the hood at a safe distance of at least 70 cm from an electric, gas or combined cooking hob. 2 Tip Adjust the level of your hood before fully tightening up the four D and E screws. 1), attach the metal chimney bracket against the wall, flush with the ceiling for support. This back-flow valve makes it possible to block the entry of air from the outside. € If a 125 mm flue is being installed, use the adapter provided (fig. If the diameter of your exterior flue is less than 125 mm, you must connect your hood in recycling mode. € Prepare your telescoping ventilation shaft, taking care not to block the vents (fig. € Adjust the length of the telescoping chimney by bringing down the lower part and fitting it into the top of the hood. 2), attach the plastic smoke deflector against the wall, flush with the ceiling for support. € Slide one end of the flue over the deflector and the other end over the motor outlet (fig. € Prepare your ventilation shaft, taking care to face the vents upward so that they are visible (B/fig. € Adjust the length of the telescoping chimney by bringing down the lower part and fitting it into the top of the hood. [. . . ] Qxp 19/01/2006 11:16 Page 63 4 / CARING FOR AND CLEANING YOUR APPLIANCE EN Warning Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. € MAINTAINING YOUR APPLIANCE MAINTENANCE WHAT TO DO PRODUCTS/ACCESSORIES TO USE Top surface and accessories Never use metal scouring pads, To clean the body and the lightabrasive products or excessively ing port, you should use only stiff brushes. Commercial household cleaning products diluted in water and then rinse using clean water, drying with a soft cloth. This component plays an important role in ensuring the effectiveness of your hood. [. . . ]