User manual BOSCH ROTAK 320

[. . . ] For products not sold in GB: B WARNING: For safety, it is essential that the mains plug 4 attached to the machine is fitted to the power supply cable 14. The couplings of connection leads must be protected against splashes and the coupling sockets on the leads must be made of rubber or coated with rubber. The power cord must be inspected for signs of damage at regular intervals and may only be used if in perfect condition. Delivered Items Carefully remove the machine from its packaging and check that you have all the following items: ­ Lawnmower with handle assembly ­ ­ ­ ­ ­ ­ ­ 2 Handle bottoms 2 Bolts 2 Wing nuts 2 Screws 2 Grassbox halves 2 Cable clips Operating instructions When parts are missing or damaged, please contact your dealer. F016 L70 483 · 06. 10 If the power cord is damaged, it must be replaced by a Bosch Service Centre. [. . . ] The safety cut out will only reset when the switch lever 1 is released. Clear any obstruction and wait for a few minutes for the safety cut out to reset before continuing to use the mower. At this time do not operate the switch lever 1 as this will prolong the reset time of the safety cut out. If the mower cuts out again increase the height of cut to reduce the load on the motor. G Blade Maintenance Stop, remove plug from the power supply and remove the grassbox. Turn the machine on its right side and inspect the blade and fan; if blunt or damaged, replace. Hold the blade 16 using gardening gloves (not provided) use a spanner (not provided) to remove the blade bolt 15, blade washer 17, bevel washer 18 and blade. Ensure that the blade is the correct way up (so that this symbol can be seen located as in figure G) and tighten the bolt firmly. In the event of a blade becoming difficult to remove or fit, insert a screwdriver into hole 19 to lock the drive. Ensure the screwdriver is removed before attempting to turn the machine on. After Mowing/Storage Clean the exterior of the machine thoroughly using a soft brush and cloth. Remove all grass and debris, especially from the ventilation slots 11. If grass cuttings are compacted in the blade area, remove with a wooden or plastic implement. To aid storage loosen the wing nuts 13 and fold the handles. Maintenance Stop, remove plug from the power supply and remove the grassbox. Note: To ensure long and reliable service, carry out the following maintenance regularly. Regularly check for obvious defects such as loose, dislodged or damaged blade, loose fixings, and worn or damaged components. If the machine should happen to fail despite the care taken in manufacture and testing, repair should be carried out by an authorised customer service agent for Bosch garden products. For all correspondence and spare parts orders, always include the 10-digit part number (TYP) from the nameplate of the machine! Ensure cables are not trapped when folding/ unfolding top handles, do not drop the handles. F016 L70 483 · 06. 10 Fault Finding The following table gives checks and actions that you can perform if your machine does not operate correctly. If these do not identify/remedy the problem, contact your service agent. Warning: Switch off and remove plug from mains before investigating fault. [. . . ] In this case, do not tilt it more than absolutely necessary and tilt only the part which is away from the operator. Always ensure that both hands are in the operating position before returning the machine to the ground. s Never operate the lawnmower without the grassbox/bag or deflector guard in position. [. . . ]