User manual BONTRAGER RACE X LITE AEROBAR

[. . . ] Check the handlebar and stem Make sure the stem is aligned with the front wheel. Test the stem connection to the fork by attempting to turn the handlebar from side to side with the front wheel locked between your knees (Figure 1). test the security of the handlebar by attempting to rotate it in the stem. Check that the handlebar plugs are properly inserted into both ends of the aerobar. [. . . ] Practice using these aerobars in a low traffic area to become accustomed to any changes in the steering or handling characteristics. Only install and use approved accessories Not all accessories are compatible or safe, so only add accessories that are approved by the manufacturer. As an example, the clamp design on some parts applies a powerful but uneven force, which Never modify your aerobar in any way, including sanding, drilling, filing, removing redundant retention devices, or by any other technique. Such modifications will void your warranty, may cause your aerobar to fail, and may contribute to loss of control resulting in personal injury or death. This section explains the possible adjustments to the position of your aerobar and the maintenance that you should regularly perform. the Race X Lite aerobar offers several adjustments to provide an increase in comfort or aerodynamics. For instructions on how to perform these adjustments, read the Installation section. Extension tube length- the distance from the handlebar to the ends of the extension tubes. slide the extension tubes forward or backward in the extension tube clamps. Move the arm rests on the arm rest adjusters, or move the handlebar clamps on the handlebar. arm pad position- the position of the arm rests relative to the front of the bike. Keep all fasteners tight Follow these maintenance suggestions to keep your aerobar in correct condition. Once a month Check that all the fasteners (screws or bolts) on your aerobar are tightened correctly: · A threaded fastener that is too loose can result in a part coming loose. The torque specifications should be used to make sure you do not over-tighten a fastener. Applying more than the recommended torque to a fastener does not provide extra holding power, and may actually lead to damage or failure of a part. If a part that is tightened to the correct torque is still loose, take the bicycle to your dealer for service. During production, threaded areas of all fasteners have been pretreated with a special blue thread-locking compound. If you cannot detect this thread locking compound or if you have cleaned it off through normal maintenance, re-apply a suitable blue thread-locking compound such as Loctite® 242 before assembly. Figure Race X Lite aerobar parts Part name A B C D E F G H I J K L M N Extension tube Bolt, extension tube pinch Nut, handlebar clamp Bracket, upper handlebar clamp Shim, upper Shim, lower Bracket, lower handlebar clamp Bolt, handlebar clamp, M x Arm pad, right Arm pad, left (not shown) Screw, arm pad holder Arm pad holder, right Arm pad holder, left (not shown) Pad width adjuster Bolt, width adjuster pinch Cable guide plug Quantity Incorrect installation of the aerobar could cause you to lose control and fall from your bicycle. If you are not familiar with the installation of aerobars, have your dealer install them. Note to Dealers: If you install this product for the consumer, please provide him or her with this owner's manual after installation of the aerobar. Make sure this aerobar is compatible with your bicycle Some lightweight aluminum or carbon fiber handlebars are not compatible with aerobar assemblies; refer to the handlebar manufacturer's installation instructions. [. . . ] this warranty is expressly limited to the repair or replacement of a defective item and is the sole remedy of the warranty. This warranty extends from the date of purchase, applies only to the original owner, and is not transferable. bontrager is not responsible for incidental or consequential damages. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusion may not Claims under this warranty must be made through an authorized Bontrager dealer. [. . . ]