User manual BONTRAGER AIR RUSH ROAD

[. . . ] When using the AirRush as an inflator, always hold the AirRush in an upright position, with the threaded neck of the cartridge pointing up (Figure 7). When carrying cartridges in the included carrier, put the cartridge grip on the upper cartridge (Figure 1). To prevent the AirRush from falling from its holder, attach the rubber clamp band. [. . . ] Turn the valve of the AirRush (Figure 4) completely to the CLOSE position. Remove the dust cover from the cartridge threads (the black side of the pump head, Figure 5). After several turns, a "puncture pin" will open the cartridge, but additional turns are required to close the seal between the cartridge and inflator. Until the seal is closed, some CO2 may escape from a punctured cartridge. After the cartridge threads are engaged, quickly tighten the CO2 cartridge into the head until snug. The cartridge grip insulates your hand; when inflating, the cartridge will get very cold. For your safety and the enjoyment of this product, please read these instructions in their entirety before using your AirRush. With one thumb, hold the tire so that the presta valve protrudes from the rim (Figure 2). With the other hand, grasp the head of the AirRush and ease it onto the presta valve. Remove the dust cap from the red the upright position side of the head of the AirRush. With one thumb, hold the tire so that the presta valve protrudes from the rim (Figure 2). With the other hand, grasp the head of the AirRush and ease it onto the presta valve (Figure 7). â· Once the AirRush is on the presta valve, you can release the tire. â· Avoid inflating the tire too rapidly--make sure the tire beads are correctly seated in the rim. [. . . ] Attempting to install a non-compatible cartridge could cause the cartridge to become a projectile. As CO2 leaves the cartridge, it drops to a very low temperature and could cause frostbite to exposed skin. â· Do not discharge the inflator towards your face or body, or other people. [. . . ]