User manual BLACK & DECKER KW850E

[. . . ] Electric safety can be further improved by using a high-sensitivity (30 mA / 30 mS) residual current device (RCD). Connect dust extraction equipment If devices are provided for the connection of dust extraction and collection facilities, ensure that these are connected and properly used. Remove adjusting keys and wrenches Always check that adjusting keys and wrenches are removed from the tool before operating the tool. When using the tool outdoors, only use extension cables intended for outdoor use. [. . . ] If you are in doubt, contact an authorised repair agent or a qualified electrician. Disconnect the plug from the supply and remove the fuse from the plug. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. If the plug has a fuse cover, make sure that the fuse cover is fitted. Using an extension cable Always use an approved extension cable suitable for the power input of this tool (see technical data). Before use, inspect the extension cable for signs of damage, wear and ageing. Use of an extension cable not suitable for the power input of the tool or which is damaged or defective may result in a risk of fire and electric shock. B) x Keep the spindle lock (7) depressed and rotate the spindle until the spindle lock fully engages. Make sure that the shank protrudes at least 3 mm from the collet as shown. X Keep the spindle lock (7) depressed and tighten the collet nut (13) using the spanner provided. X Insert the two screws (16) from the bottom through the holes in the base and in the dust extraction adaptor. M & D) x Fit the template guide (20) to the base of the router, with the flange to the bottom (= workpiece) side. X Insert the two long screws (16) from the bottom side through the template guide and the holes in the base. N) x Fit the distance piece (21) to the base of the router using the screws provided. Dust extraction adaptor ASSEMBLY Before attempting any of the following operations, make sure that the tool is switched off and unplugged and that the spindle has stopped. X Fit the centring pin (22) to the workpiece side of the edge guide with the screw (23) provided. X Fit the `L' bar (24) to the upper side of the edge guide using the two screws and nuts provided. [. . . ] Regularly clean the ventilation slots in your tool using a soft brush or dry cloth. PROTECTING THE ENVIRONMENT Black & Decker provides a facility for recycling Black & Decker products once they have reached the end of their working life. To take advantage of this service please return your product to any authorised repair agent who will collect them on our behalf. Hints for optimum use x When working on outside edges, move the tool counterclockwise (fig. [. . . ]