User manual BLACK & DECKER KG 725

[. . . ] Guard against electric shock Prevent body contact with earthed or grounded surfaces (e. Electric safety can be further improved by using a high-sensitivity (30 mA / 30 mS) residual current device (RCD). Connect dust extraction equipment If devices are provided for the connection of dust extraction and collection facilities, ensure that these are connected and properly used. Remove keys and adjusting wrenches Always check that keys and adjusting wrenches are removed from the tool before operating the tool. [. . . ] 8 x x Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorised repair agent or a qualified electrician. Disconnect the plug from the supply and remove the fuse from the plug. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. If the plug has a fuse cover, make sure that the fuse cover is fitted. P65 8 17-07-2001, 14:51 ENGLISH Do not use the plug if the fuse cover is missing or damaged. Using an extension cable Always use an approved extension cable suitable for the power input of this tool (see technical data). Before use, inspect the extension cable for signs of damage, wear and ageing. Use of an extension cable not suitable for the power input of the tool or which is damaged or defective may result in a risk of fire and electric shock. cARTON CONTENTS The carton contains: 1 Angle grinder 1 Side handle 1 Flange set 1 Two-pin spanner 1 Wrench (KG68/CD500) 1 Instruction manual x x Fitting the side handle (fig. A) x Screw the side handle (2) into one of the mounting holes in the tool. Please note that additional items may be found in the carton, depending on the letter suffix following the catalogue number of your tool. A) On/off switch Side handle Spindle lock (KG70/KG75) Guard Grinding or cutting disc ASSEMBLY Before attempting any of the following operations, make sure that the tool is switched off and unplugged. Always use discs with the correct diameter and bore size (see technical data). The maximum thickness for grinding discs is 6 mm, for cutting discs 3. Make sure that the flange is correctly located on the flat sides of the spindle. If the disc has a raised centre (11), make sure that the raised centre faces the inner flange. X Make sure that the disc locates correctly on the inner flange (not for KG70). P65 9 17-07-2001, 14:51 ENGLISH x x x x KG70: Place the outer flange (12) onto the spindle with the raised centre facing towards the disc (A in fig. [. . . ] Sjekk verktyet for skader Kontroller verktyet og strmledningen grundig for skade fr bruk. Pass p at maksimal hastighet for kappe- eller slipeskiven er hyere enn ubelastet hastighet for verktyet. Strk dig ikke for meget Srg for, at du altid har sikkert fodfste og balance. Kontrollr vrktjet for skader Kontrollr omhyggeligt vrktjet og netkablet for beskadigelser, fr det tages i brug. [. . . ]