User manual BLACK & DECKER KC2000

[. . . ] UK Ireland Australia New Zealand 1 11 8 7 3 10 9 3 2 1 6 4 2 1 5 5 13 14 12 6 14 13 12 A 2 3 2 6 5 6 5 B C 9 17 7 15 16 21 2 1 D E F 20 18 G 1 2 H 19 I J 22 K 3 Intended use Your Black & Decker multi-purpose tool has been designed for a wide range of DIY applications. Using the drill/screwdriver head, this tool is intended for screwdriving applications and for drilling in wood, metal, plastics and soft masonry. Using the jigsaw head, this tool is intended for sawing wood, metal and plastics. Using the sander head, this tool is intended for sanding wood, metal, plastics and painted surfaces. [. . . ] x Firmly tighten the chuck by turning the front part (15) with one hand while holding the rear part (16) with the other. This tool is supplied with a double-ended screwdriver bit in the bit holder (4) (fig. x To remove the screwdriver bit from the bit holder, lift the bit from the recess. F & G) x Lock the tool by setting the forward/reverse slider (2) to the centre position (fig. x To fit a saw blade, lift the lever (18) and hold it in this position (fig. x To remove the saw blade, lift the lever (18) and pull the saw blade from the holder. x Lock the tool by setting the forward/reverse slider (2) to the centre position (fig. x Before fitting a new sheet, remove the two additional diamond tips (20) (fig. x Press the sheet firmly and evenly onto the sanding base, making sure that the holes in the sheet coincide with the holes in the base. x To remove the sheet, pull it off the sanding pad. Assembly Warning!B) KC2000 x To fit the battery (5), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. x To remove the battery, push the two release buttons (6) simultaneously while at the same time pulling the battery out of the receptacle. KC2002 x To fit the battery (5), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. 6 Warning!Never use the sanding head without a sanding sheet or accessory in place. F & J) Sanding sheets are supplied with two replacement diamond tips. x Lock the tool by setting the forward/reverse slider (2) to the centre position (fig. x To reverse the tip, remove it, turn it 180° and press it back onto the base as shown (fig. x To replace the tip, pull the old tip off the base and press a new one onto the base. When removing the tip from the pad, be careful not to pull the pad off the sanding base. Selecting the torque or drill position (fig. E) This tool is fitted with a collar to set the torque for tightening screws. [. . . ] Regularly open the chuck and tap it to remove any dust from the interior. Regularly apply a drop of light machine oil to the guide roller (22) of the jigsaw head (fig. K). Protecting the environment Tools Black & Decker provides a facility for recycling Black & Decker products and rechargeable batteries once they have reached the end of their working life. To take advantage of this service please return your product to any authorised repair agent who will collect them on our behalf. [. . . ]