User manual BLACK & DECKER KA160

[. . . ] Check for damaged parts Before use, carefully check the tool and mains cable for damage. Check for misalignment and seizure of moving parts, breakage of parts, damage to guards and switches and any other conditions that may affect its operation. ensure that the tool will operate properly and perform its intended function. Have any damaged or defective parts repaired or replaced by an authorised repair agent. [. . . ] Electrical safety This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate. Additional safety instructions for sanders Always wear a dust mask whenever sanding. Before using the tool on wooden workpieces, make sure to fit dust extraction equipment. Before using the tool on metal workpieces, make sure to remove the dust extraction equipment. Hearing protection should be worn whenever the sound level seems uncomfortable. Sanding lead-based paint or MDF Sanding of lead-based paint is not recommended due to the difficulty of controlling the contaminated dust. The greatest danger of lead poisoning is to children and pregnant women. Any pre-1960 building may in the past have been painted with paint containing lead. Before starting work, it is important to determine whether the paint to be sanded contains lead. Personal protection Do not let children or pregnant women enter the work area. Wear a dust mask specifically designed for protection against lead paint dust and fumes and ensure that persons within or entering the work area are also protected. Environment Remove the paint in such a way that the amount of dust is minimised. Cleaning Thoroughly vacuum and clean all surfaces in the work area every day. Thoroughly wash any foreign objects exposed to dust before using them again. Additional safety instructions for Australia and New Zealand This appliance is not intended for use by young or infirm persons without supervision. Children must be supervised to ensure they do not play with the appliance. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. Sanding profiles In addition, this tool is supplied with some or all of the following accessories: Accessory - Coarse grit sandpaper Medium grit sandpaper Fine grit sandpaper Extra fine grit sandpaper Detail sanding tips 1 OT polishing/ stripping wool Grey foam pad Red non-woven pad Grey abrasive paper Contour attachments Recommended application and use Fast paint, varnish and rust removal Paint, varnish and rust removal Surface blending and finishing Sanding between coats Corners and hard to reach places Polishing metals, stripping varnish and glass cleaning Applying and removing polish Heavy scrubbing and rust removal Polishing plastics Curves and profiles Make sure that the tool is switched off and unplugged. A & B) Detach the two diamond-shaped tips (10) from the sanding sheet (11). Place the sanding sheet (11) onto the sanding base, making sure that the holes in the sheet line up with the holes in the base. When the front part of the tip is worn, detach it from the sheet, reverse it and press it onto the sanding base again. [. . . ] You can check the location of your nearest authorised repair agent by contacting your local Black & Decker office at the address indicated in this manual. Alternatively, a list of authorised Black & Decker repair agents and full details of our after-sales service and contacts are available on the Internet at: www. This guarantee statement is in addition to and in no way prejudices your statutory rights. the guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area. [. . . ]