User manual BLACK & DECKER KA150K

[. . . ] It will do the job better and more safely at the rate for which it was intended. Do not force small tools or attachments to do the job of a heavy duty tool. Do not use the tool for purposes not intended; for example, do not use a circular saw to cut tree limbs or logs. Do not wear loose clothing or jewellery as they can be caught in moving parts. [. . . ] Sanding should be done in a manner to reduce tracking of paint dust outside the work area. CLEANING AND DISPOSAL All surfaces in the work area should be vacuumed and thoroughly cleaned daily for the duration of the sanding project. Items of clothing, dust sheets, toys, washable furniture and utensils should be washed thoroughly before being used again. This means that all the external metal parts are electrically insulated from the mains power supply. This is done by placing insulation barriers between the electrical and mechanical components making it unnecessary for the tool to be earthed. Note: Double insulation does not take the place of normal safety precautions when operating the tool. The insulation system is for added protection 20 against injury resulting from a possible electrical insulation failure within the tool. ELECTRICAL SAFETY Be sure the supply is the same as the voltage given on the rating plate. MAINS PLUG REPLACEMENT (UK ONLY) Should the mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact a Black & Decker service agent or a qualified electrician. A plug with bared copper conductors is very dangerous if engaged in a live socket outlet. Only fit BS1363A approved plugs fitted with the correctly rated fuse. The cable wire colours, or a letter, will be marked at the connection point of most good quality plugs. attach the wires to their respective points in the plug (see diagram). Fit a 5 amp fuse approved to BS1362 Connect brown to L (live) Make sure that the outer sheath of the 230 volts AC only cable is held firmly Never use a light by the clamp socket · Before replacing the top cover of the plug ensure that the cable restraint is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Black & Decker service agent because special purpose tools are required. EXTENSION CABLES Up to 30m (100ft) of 3-core extension cable can be used without undue loss of power. Note: An extension cable should not be used unless absolutely necessary. Use of an improper extension cable could result in a risk of fire and electric shock. If an extension cable must be used, make sure it is properly wired, contains the correct rated fuse as recommended in its literature and is in good electrical condition. UNWANTED TOOLS AND THE ENVIRONMENT Should you find one day that the tool needs replacement or is of no further use, think of the protection of the environment. Black & Decker service agents will accept old tools and will dispose of them in an environmentally safe way. [. . . ] Looking from the bottom of the Mouse rotate the base in a clockwise direction whilst holding the Mouse in one hand and the base in the other. Take the finger 1 attachment base and locate the three legs into 2 the location holes in the Mouse. turn the finger attachment base anti clockwise as shown to attach the base. Note: The screws must be placed back into the base for the unit to work properly. [. . . ]