User manual BLACK & DECKER JU300CB

[. . . ] Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. When not in use, appliances should be stored indoors in dry, and high or locked-up place ­ out of reach of children. It will do the job better and with less likelihood of a risk of injury at the rate for which it was designed. Do not use the appliance for any job except that for which it is intended. [. . . ] Always disconnect the NEGATIVE (BLACK) jumper cable first, followed by the POSITIVE (RED) jumper cable, except for positive grounded systems. ⷠDo not expose battery to fire or intense heat since it may explode. Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire). ⷠPlace this unit as far away from the battery as DC cables permit. ⷠNever allow battery acid to come in contact with this unit. ⷠDo not operate this unit in a closed area or restrict ventilation in any way. ⷠFIRST AID ­ SKIN: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly with soap and water. if redness , pain , or irritation occurs , seek immediate medical attention. EYES: If battery acid comes in contact with eyes, flush eyes immediately, for a minimum of 15 minutes and seek immediate medical attention. Fully charge unit with a household extension chord (not supplied) for a full 24 hours before using for the first time. ⷠAll On/Off switches should be in the OFF position when the unit is charging or not in use. Make sure all switches are in the OFF position before connection to a power source or load. ⷠNever insert anything other than the supplied recommended appliance power/recharging cords into the 12 volt DC power outlet on this unit. ⷠDo not use any accessory that is not recommended or provided by the manufacturer. ⷠDo not use this unit to operate appliances that need more than 5 amps to operate from the 12 volt DC accessory outlet. ⷠThis system is designed to be used only on vehicles with a 12 volt DC battery system. This system is not designed to be used as a replacement for a vehicular battery. Do not attempt to operate a vehicle that does not have a battery installed. If the engine fails to start after the recommended number of attempts, discontinue jump-start procedures and look for other problems that may need to be corrected. Although this unit contains a non-spillable battery, it is recommended that unit be kept upright during storage, use and recharging. To avoid possible damage that may shorten the unit's working life, protect it from direct sunlight, direct heat and/or moisture. Follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you intend to use with this unit. [. . . ] Note: This check may not be accurate for every make, manufacturer and model of vehicle. Each nozzle will clip on the end of the standard tire valve connector located at the free end of the inflator hose. The inflator hose with tire fitting is stored in a retaining channel between the jumper cable channels on the rear of the unit. The inflator can operate long enough to fill up to 3 average sized tires before the battery must be recharged. [. . . ]