User manual BLACK & DECKER HP14K

[. . . ] Dress properly Do not wear loose clothing or jewellery, as these can be caught in moving parts. Preferably wear rubber gloves and non-slip footwear when working outdoors. Use a face or dust mask whenever the operations may produce dust or flying particles. Connect dust extraction equipment If devices are provided for the connection of dust extraction and collection facilities, ensure that these are connected and properly used. [. . . ] If you are in doubt, contact an authorised repair agent or a qualified electrician. Disconnect the plug from the supply and remove the fuse from the plug. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with a 5 A fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. If the plug has a fuse cover, make sure that the fuse cover is fitted. Do not use the plug if the fuse cover is missing or damaged. Fitting and removing the battery (fig. B) N To fit the battery (9), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. N To remove the battery, push the release button (10) while at the same time pulling the battery out of the receptacle. A & C) This tool is fitted with a keyless chuck to allow for an easy exchange of bits. N Lock the tool by setting the forward/reverse slider (2) to the centre position (fig. N Open the chuck by turning the front part (16) with one hand while holding the rear part (17) with the other (fig. N Firmly tighten the chuck by turning the front part (16) with one hand while holding the rear part (17) with the other. This tool is supplied with a double-ended screwdriver bit in the bit holder (8) (fig. N To remove the screwdriver bit from the bit holder, lift the bit from the recess. N To store the screwdriver bit, firmly push it into the holder. Never use a light socket. Variable speed switch (HP12K(D)/HP14K(D)/ HP122K(D)/HP142K(D)) 10 ENGLISH HP12KD/HP14KD/HP122KD/HP142KD Attaching the detector (fig. K) The tool provides a mounting location where the detector (23) is stored when not in use. N Hang the unit to the holder (24) as shown. USE Let the tool work at its own pace. If the green end of charge indicator (15) lights up now instead, the battery is too hot and cannot be charged. [. . . ] This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area. If a Black & Decker product becomes defective due to faulty materials, workmanship or lack of conformity, within 24 months from the date of purchase, Black & Decker guarantees to replace defective parts, repair products subjected to fair wear and tear or replace such products to ensure minimum inconvenience to the customer unless: N The product has been used for trade, professional or hire purposes; N The product has been subjected to misuse or neglect; N The product has sustained damage through foreign objects, substances or accidents; Batteries Black & Decker batteries can be recharged many times. At the end of their useful life, discard batteries with due care for our Cd environment: N Run the battery down completely, then remove it from the tool. [. . . ]