User manual BLACK & DECKER GT6060

[. . . ] Safety instructions General power tool safety warnings @ Warning!Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool" in the warnings refers to your mains operated (corded) power tool or battery operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] The declared vibration emission value may also be used in a preliminary assessment of exposure. The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. When assessing vibration exposure to determine safety measures required by 2002/44/EC to protect persons regularly using power tools in employment, an estimation of vibration exposure should consider, the actual conditions of use and the way the tool is used, including taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time. Always check that the power supply corresponds to the voltage on the rating plate. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. U When using the tool outdoors, only use extension cables intended for outdoor use. A suitable rated Black & Decker extension cable of up to 30 m can be used without loss of power. U Electric safety can be further improved by using a highsensitivity 30 mA residual current device (RCD). U Features This tool includes some or all of the following features. Cable restraint Labels on tool The following pictograms are shown on the tool: : Assembly O E Warning!To reduce the risk of injury, the user must read the instruction manual. Before assembly, make sure that the tool is switched off and unplugged and that the blade sheath is fitted over the blades. Immediately disconnect the cable from the mains if it is damaged or cut. Unless the tool is fitted with a mains cable, you will need to connect an extension cable to the power inlet. U Connect the female socket of a suitable extension cable to the power inlet of the tool. U Loop the cable through the cable restraint (6) as shown to prevent the extension cable from becoming detached during use. Accessories Switching on and off Note: For your safety, this tool is equipped with a double switching system. This system prevents starting the tool inadvertently and will only allow operation while holding the tool with both hands. B) u Take hold of the front handle (3) with one hand so that the front handle bail arm (2) is pushed into the body of the front handle. U With the other hand, squeeze the trigger switch (1) to start the tool. Switching off u Release the handle bail arm (2) or the trigger switch (1). Black & Decker and Piranha accessories are engineered to high quality standards and designed to enhance the performance of your tool. [. . . ] Uk to register your new Black & Decker product and to be kept up to date on new products and special offers. Further information on the Black & Decker brand and our range of products is available at www. Vid garantianspråk ska produkten och inköpskvittot lämnas till återförsäljaren eller till en auktoriserad verkstad. Bruk av personlig verneutstyr, for eksempel støvmaske, sklisikre vernesko, hjelm eller hørselvern som passer til forholdene, reduserer risikoen for personskader. [. . . ]